User manual AEG-ELECTROLUX AEG3030B

[. . . ] For more detail see the Installation Instructions. We recommend you read pages 20 & 21 if you have not used a gas cooker before. We describe some basic guidelines on how to use a gas cooker safely. Gas and Electricity on Make sure that the gas supply is turned on and that the cooker is wired in and switched on. The cooker needs electricity. Peculiar smells When you first use your cooker it may give off a slight odour. [. . . ] Contact your retailer. 22 Australia Installation Dear Installer Before you start your installation, please complete the details BELOW. If your customer has a problem relating to your installation they will be able to contact you easily. Thank you Installer's Name Installer's Company Installer's Telephone number 23 Australia You must be aware of the following safety requirements & regulations Safety Requirements/Regulations The cooker must be installed in accordance with these instructions by an authorised person. The installation must be in accordance with AS 5601/AG 601 - Gas Installations, local gas fitting regulations, municipal building codes, electrical wiring regulations and any other relevant statutory regulations. Read the instructions before installing or using this appliance. In your own interest and that of safety, it is law that all gas appliances be installed by an authorised person. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution. Before installation, ensure that cooker is suitable for your gas type and supply voltage. Warning: Where this appliance is installed in marine craft or in caravans, it shall not be used as a space heater. This appliance is designed for domestic cooking only. Use for any other purpose could invalidate any warranty or liability claim. Ventilation Requirements Ventilation must be as specified by `AS 5601/AG 601 - Gas Installations'. (This means turning and removing the levelling tool 20 times). 27 Australia Fitting the stability bracket A stability bracket and chain should be fitted when the cooker is connected to a flexible gas supply. When fitting a stability bracket read these instructions together with the leaflet supplied with the bracket. Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker. Carefully push the cooker backwards off the pack base and into position. Take care not to damage the power cable. Push the cooker close to its final position, leaving just enough space to get behind it. 1. Place the cooker in its intended position and level the cooker. 2. Draw a pencil line 100mm from the front edge of the levelling feet. 3. Mark the centre line for the bracket by measuring 550mm from the left hand side of the cooker. 4. Lower the front roller and move the cooker forward. 5. Measure back from the pencil line 550mm to locate the front edge of the bracket. [. . . ] Remove the screws securing the cover and lift clear. Pull off all the leads to the generator noting their positions. Slacken the two screws holding generator to cooker and remove generator. Fit new generator to cooker and replace leads. [. . . ]