User manual AEG-ELECTROLUX AEG3030W

[. . . ] Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Extractor version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Filter Version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Control Panel - 8160 D - 8190 D - 8260 D - 8290 D . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] -- keep the hose as large as possible (preferably the same diameter as the outlet hole). · Failure to observe these basic instructions will drastically reduce the performance and increase the noise levels of the extractor hood. 4 Description of the Appliance · The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. · You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version · In this version fumes are extracted to the outside via a hose connected to the coupling ring A. 1 · In order to obtain the best performance the hose should have a diameter equal to the outlet hole. · Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/ 125 mm reduction flange provided. In this case the hood will be slightly noisier. Filter Version · The air is filtered through an charcoal filter and returned to the kitchen through the top grill of the outlet pipe. · You will need an original AEG charcoal filter for the filtering function. · Fix the deflector using 2 screws Ø 2, 9x13 mm. · Optionally, the position of the chimney elements can be changed. When using the hood in the filter version the chimney must be fixed at the top, with the air outlet grill at the side. Fig. 2 5 Control Panel · Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. · Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 8 Charcoal filter · The charcoal filter should only be used if you want to use the hood in the recirculation function. · To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). · Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. [. . . ] If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The safety cut-out device has been tripped. Turn off the hob and then wait for the device to reset. [. . . ]