User manual AEG-ELECTROLUX AG72RF

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. and please pass it to any future owner of the appliance. [. . . ] The temperatures of the hob, which in part are quite high, may damage the appliance. If a hob is installed near the appliance, the corresponding installation and safety instructions must be adhered to. Considering the numerous installation conditions which are possible, there is no way of providing detailed information here. It is necessary to avoid overheating of the refrigerator by maintaining adequate distances from heat sources and by the use of a suitable thermal insulation plate. Proper ventilation of the appliance must also be ensured. Your appliance needs air for safety reasons , minimum ventilationmust be as shown Fig. Attention: keep ventilation openings clear of obstruction; Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Power cut) warning light (H) will start to flash and a buzzer will sound. After the temperature has returned to normal, the warning light (H) will continue to flash, although the buzzer has stopped. The warning tone sounds if the door is left open for more than 80 seconds. â· You can switch off the warning tone by closing the door. To switch off, hold down the ON/OFF button for approx. This will result in a countdown from "3" to "1" taking place in the temperature display. Note: The appliance cannot be switched on or off if unplugged, or if there is no power being supplied to it. Following connection to the mains power supply, the appliance returns to the same operating state as before the interruption of main power. If the appliance is not going to be used for an extended period: Switch off the appliance, holding down the ON/OFF button until the display goes off (see above). Remove the mains plug or switch off or turn out the circuit breaker or fuse. defrost the freezer compartment and clean the appliance thoroughly (see section: "Cleaning and Maintenance"). [. . . ] After cleaning replace the protection and fix with both screws. Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. Do not place warm foods into the appliance. [. . . ]