User manual AEG-ELECTROLUX AG91854-4I

[. . . ] Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] After having drilled holes, fix the guide with the screws supplied. Fix cover (Hc) on guide (Ha) until it clips into place. Insert the small square (Hb) into guide (Ha). put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. Fix cover (Hd) on guide (Hb) until it clips into place. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. Mains pilot indicator (green) Freezer button ON/OFF Temperature setting button (+) Temperature display Temperature setting button (-) FROSTMATIC function "on" indicator (yellow) FROSTMATIC button Alarm reset light Alarm reset button The temperature is adjusted using the , , C" and , , E" buttons. These buttons are connected to the temperature display. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, , , C" or , , E". Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the freezer (ACTUAL temperature) is displayed. [. . . ] Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. Keep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. [. . . ]