User manual AEG-ELECTROLUX AJM 6810

[. . . ] The above can cause serious damage to the motor, which is not covered by the warranty. If the cord is damaged, it must be replaced only by an authorized AEG service centre in order to avoid a hazard. Before starting 22 Open the front cover on the machine and check that the dust bag s-bag® and the motor filter are in place. [. . . ] Replacing the dust bag, s-bag® 38 The dust bag, s-bag® must be replaced latest when the indicator window is completely red. 39 Open the front lid and lift out the Air Basket containing the s-bag® (40). 42 Insert a new s-bag® by pushing the cardboard right into the groove of the Air Basket, close it and put the Air Basket back into the cleaner. Be sure to use only original s-bag® dust bags ­s-bag® classic, s-bag® classic long performance, s-bag® HEPA anti-allergy, or s-bag® anti-odour. Never use the vacuum cleaner without a filter. 43 Open the front lid and lift out the Air Basket holding the s-bag®. EF17 this type of filter can not be washed and must be replaced with a new one. 47 Close the lid inserting the front hooks into the rails. Push the lid forward and press down in the centre until both sides click in. Cleaning the HEPA H12 Washable Filter* If you have a HEPA H12 Washable exhaust filter*, wash the filter once a year. If the filter is damaged, replace it with a new filter. 46 To clean the HEPA H12 Washable filter*, rinse the inside (dirty side) in lukewarm tap water. Let dry thoroughly and then reinsert into the cleaner as above. note: Do not use cleaning agents and avoid touching the filter surface. [. . . ] Let the cleaner cool down for 30 minutes before plugging it in again. For any further problems, contact an authorized AEG service centre. Consumer information and sustainability policy AEG declines all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. [. . . ]