User manual AEG-ELECTROLUX ARC1310I

[. . . ] INSTRUCTION BOOKLET MIXED FUEL COOKER CSIG 223 W Please read this instruction booklet before using the appliance 1 Important Safety Information You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950 Installation q This cooker must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant British Standards. q When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooker. Unstable or misshapen pans should not be used on the hob burners as unstable pans can cause an accident by tipping or spillage. Never leave the cooker unattended when cooking with oil and fats. [. . . ] If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Centre who will be pleased to advise further. 14 Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. Oven Shelves To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. Oven lamp replacement Disconnect the appliance. Unscrew the lamp and substitute it with another suitable for higher temperature (300°C) having the following specifications: Voltage: Power: Connection: 230-240V (50Hz) 15W E14 FO 0424 flap. -- Remove the smallremainder of the lid. When cleaning around the flame spreader, particles can fall into the drawer below. We recommend placing some paper over the contents of the drawer whilst cleaning. Please ensure the paper is removed after cleaning or it may ignite, when the oven is next used. We advise using a stiff dry brush to remove stubborn grease deposits around the base of the unit (see Fig. ). Remove any remaining surface fat with a sponge while the oven is still warm. Place a brush or other suitable cleaning implement into the aperture and brush around the base of the unit with a suitable detergent. UNDER NO CIRCUMSTANCES SHOULD THE FLAME SPREADER BE REMOVED. After cleaning, replace the lids correctly. FO 0177 Cleaning around the flame spreader FO 0176 15 Something Not Working If the appliance is not working correctly, please carry out the following checks, before contacting your local Parkinson Cowan Service Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM s There is no spark when lighting the gas SOLUTION x Check that the unit is plugged in and the electrical supply is switched on x Check that the RCCB has not tripped (if fitted) x Check the mains fuse has not blown x Check the burner cap and crown have been replaced correctly, e. g. x Check the main jet is not blocked and the burner crown is clear of food particles. x Check the burner cap and crown have been replaced correctly, e. g. x Check a cooking function / temperature have been selected. x Check the socket switch or the switch from the mains supply to the oven is ON. s The gas ring burns unevenly s The oven does not come on s The oven light does not come on x Check the light bulb, and replace it if necessary (see "Replacing the Oven Light") s It takes too long to finish the dishes, or they are cooked too fast. s Steam and condensation settle on the food and the oven cavity. x The temperature may need adjusting x Refer to the contents of this booklet, especially to the chapter "Using the Oven". [. . . ] C. THIS COOKER MUST BE EARTHED. -- Connect the green and yellow (earth) wire to the terminal in the plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow. -- Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter 'N' or coloured black. -- Connect the brown (live) wire to the terminal in the plug which is marked with the letter 'L' or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. [. . . ]