User manual AEG-ELECTROLUX ARC2202GT S-SF

[. . . ] It is imperative that this information is observed. 0 1. This symbol guides you step by step through the operation of the appli- ance. . . . 3 2 Next to this symbol you will find additional information and practical tips on using the appliance. Tips and information on economical and environmentally responsible use of the unit are identified with the clover leaf. [. . . ] First carry out emergency emptying (see section "Carrying out emergency emptying"). Place a towel on the floor in front of the cover of the drain pump. Unscrew the drain pump cover anticlockwise and pull it out. 1 4. Remove any foreign objects, fluff and strands of fabric from the drain pump. 5. Check that you are able to turn the pump wheel at the very rear of the pump housing. (If the wheel rotates with a jerky motion, this is normal. ) If you cannot turn the pump wheel, contact customer service. 6. Insert the webs on the cover laterally into the guide slots and screw on the cover securely clockwise. 7. Close the emergency emptying hose and place it in the holder. 8. 27 Operating Instructions What to do if . . . Remedying Faults In the event of a fault, try to solve the problem yourself with the aid of the information provided here. If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. Problem Possible cause Remedy The mains plug is not inserted. There should be an audible click. Press and hold the START/ The START/PAUSE button was PAUSE button until the pronot pressed for long enough. In the case of easycare fabrics, select the EASY IRON programme. Contact your local Service Force Centre. For pumping heights over 1 m a conversion kit is available as a special accessory. Switch off the machine and disconnect the mains plug. Wait until the programme has ended, the DOOR light goes off and the END light is lit. The door cannot be opened when the washing machine Door is locked due to high is on. water level, or high temperaSTART/PAUSE ture. If it is necessary to open the door immediately, Turn the programme selector to OFF; then turn it to DRAIN. When the water has been pumped out, the door can be opened. The programme continues when power is restored. Power failure during a wash programme (all indicator lights are off). [. . . ] 49A/B, Jalan Petaling Utama 7 4600 Petaling Jaya Tel. : 3 795 1084 Fax: 3 795 1082 Saudi Arabia Alia Trading Corporation P. O. Box 4101 King Abdul Aziz Street Riyadh Tel. : 4645977 Al Nahas Est. Box 1 15 29 Jeddah Tel. : 6606852 Slovenia Electrolux Slovenia D. O. O. 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Japan Electrolux Japan Ltd. [. . . ]