User manual AEG-ELECTROLUX ARC2685-4GT

[. . . ] You must read them carefully before installing or using the appliance!This product is designed to be operated by adults. Children shouId not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician. [. . . ] After sufficient cooling (approximately 5 hours), the thermostat position can be set to a lower temperature, between 2-5. The thermostat will now automatically regulate the set temperature. 1) 3-way-switch (D) should be in position 230V. 4 Turn thermostat knob (A) anticlockwise to position '0'=off (a slight resistance will be felt just before this position). D/C operation Do not use any additional form of energy (mains/gas). A safety fuse must be installed in the electricity supply between battery and refrigerator in a duct. 12 V: maximum 15 amps; 24 V: maximum 7. 5 amps, Cable cross section 2. 5 mm2 4. 0mm2 6. 0 mm2 max. cable lengths 12V 24 V 2. 5 m 5m 4. 0m 8m 6. 0m 12m until until until It is not necessary to consider the polarity when connecting the unit. Check that the battery voltage and line voltage data correspond to the type-plate on the back of the unit. If no batteries are used independently of the vehicle, the mobile cooler should not be operational when the vehicle is in motion, since the battery can discharge to the extent that the vehicle engine cannot restart when the vehicle is at a standstill. During transport, the door safety button (G) must remain depressed, so that the door is kept in a closed and safe position. Recommendation: before journey, pre-cool the unit using A/C operation. (This could take longer than 10 seconds if the unit has been out of operation for a prolonged period or after replacing the gas cylinder. Cause: air in the pipes. ) After ignition, hold down knob (B) for a further 20-30 seconds before releasing. The flame can be controlled by aperture (C). Should no ignition occur, repeat the ignition process after 1 minute. When a sufficient low internal temperature of the refrigerator has been reached it may be necessary to set the control knob (F) to MIN-position, particularly at night, in cool weather conditions or when the refrigerator is only lightly loaded respectively the ambient temperature is below +18°C, in order to avoid overfreezing the contents. 12. Close gas cylinder or pressure regulating valve. Turn knob (B) clockwise to the off position. 13. Food and drink storage - Foodstuffs and drinks should always be stored sealed in the unit. Thus, changes in taste and smell are avoided. Food and drink should be placed in the cooler so as to allow air to circulate freely. Do not place hot food or drinks in the cooler! [. . . ] After a few minutes return the refrigerator to its correct position and switch on again. Should the unit still not function correctly, repeat the process several times. 16. Maintenance Changing the gas filter: the cellulose gas filter is situated at the back in the gas connection piece. When it becomes necessary to replace the gas filter, remove the filter from the duct and replace it with a new one. [. . . ]