User manual AEG-ELECTROLUX ARC2790-4GA

[. . . ] ÖKO-ARCTIS no-frost-Gefrierautomaten electronic no-frost-freezing appliance electronics Sistema elettronico per congelatori no-frost Gebrauchsanweisung Operating Instructions Istruzioni per l'uso Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Note: · The red warning display and the audible warning are inoperable: ­ after temperature adjustment, until the selected SET temperature has been reached (exception: actual temperature exceeds -10°C). · Only the audible warning is inoperable: ­ after the appliance is switched on, and until the selected SET temperature has been reached for the first time; ­ when the FAST FREEZE button is depressed. Partial/Complete Thaw Warning If frozen goods have been partially or completely thawed (e. g. during a temporary power interruption), the red warning display blinks. In addition the temperature display alternately indicates: ­ the highest temperature to which the frozen goods have warmed; ­ and the current actual temperature in the freezer compartment. If suspicion of partial or complete thawing exists, please check the quality of the foods to determine if they can be used. As soon as the temperature in the freezer compartment has again fallen below the critical thawing temperature of -4°C, the partial/ complete thaw warning can be switched off with the WARNING OFF button. 3 After the appliance has been switched on, the partial/complete thaw warning remains inoperative until the selected SET temperature has been reached for the first time. Function Errors If the appliance electronics have detected a technical malfunction which has to be corrected by a customer service technician, both optical and acoustic warnings are activated. In addition the temperature display alternately indicates: ­ an error message (error code F1, F2, etc. ) and ­ the current freezer compartment temperature (actual temperature). 58 3 An appliance malfunction which is indicated by an error code, must be corrected by a customer service technician. The acoustic warning can be switched off for 24 hours with the WARNING OFF button. Cancelling of the error display is possible by switching the appliance off, which should however only be undertaken during repair by the customer service technician. Freezing Freezing Attention!· Before foods are frozen, the actual temperature in the freezer compartment must be -18°C or colder. · Please observe indicated freezing capacity on the serial plate. The freezing capacity represents the maximum amount of fresh goods that can be frozen within 24 hours. If you freeze goods on several days, one after the other, freeze amounts equal to 2/3 to 3/4 of the capacity indicated on the serial plate. · Thawed foods which have not been processed further (cooked into meals) may not under any circumstances be frozen a second time. 0 For exploitation of maximum freezing capacity press the FAST FREEZE button 24 hours prior to freezing, or 4 to 6 hours for smaller quantities. The FAST FREEZE button need not be pressed for freezing of small quantities of up to 3 kg. 0 All foods must be packed air tight prior to freezing, so that they do not dry out or lose their flavour, and so that no flavour contamination of other frozen goods occurs. Do not touch frozen goods with wet hands. 0 Place packaged foods in the compartments or drawers. Unfrozen goods may not come into contact with already frozen goods, otherwise the frozen goods may start to thaw. 3 3 The appliance electronics recognise automatically when the FAST FREEZE function can be ended, and switch it off automatically. You can also stop the FAST FREEZE function manually by pressing the FAST FREEZE button again. 59 Freezing · To allow storage of awkward freezing foodstuff, the drawers of the appliance are individually removable. [. . . ] When changing the side at which the door opens, the appliance may not be connected to the mains. Lay the left side of the appliance onto a soft pad, e. g. Keep the spacing washer between the door and the bearing. Turn the 4 phillips head screws out of the base and remove the base. 0 Overturn the plinth's blind bearing from left to the right. 0 Unscrew the door bearing and transfer it to the left. 74 Installation and Connection 0 Screw the plinth again and place the appliance on it. [. . . ]