User manual AEG-ELECTROLUX ARC4102GTGB

[. . . ] Damage to the vacuum cleaner's cord is not covered by the warranty. Never pull or lift the vacuum cleaner by the cord. all servicing and repairs must be performed by an authorized AEG-Electrolux service centre. Store the vacuum cleaner in a dry place. [. . . ] Make sure the brushes on the nozzle are down to prevent scratching the floor surface. Reduce suction power for short pile small carpets. With the Dust Magnet* nozzle there is normally no need to switch mode (33a). It can be used with brush up on all surfaces for maximum convenience with maintained excellent dust removal result. The (33b) brush setting should be used to reach optimal dust removal on difficult hard floors or to get a combing effect on carpets. wooden floors: Use the parquet nozzle* (34). Upholstered furniture and fabrics: Use the upholstery nozzle* (35) for sofas, curtains, lightweight fabrics etc. 32a 32b 33a 33b 34 Using the turbo nozzle* 37a/b Ideal for carpets and wall-to-wall carpeting to remove stubborn fluff and pet hairs. Note: Do not use the turbo nozzle on animal skin rugs or carpet fringes. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. Let dry thoroughly and then reinsert into the cleaner as above. 44 45 46 Note: Do not use cleaning agents and avoid touching the filter surface. Let the filter dry completely before putting back!In such cases, disconnect from mains and allow to cool for 20-30 minutes. 49 Hose handle can be dismantled from hose if cleaning is needed. 50 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose. 49 50 Note: The warranty does not cover any damage to the hose caused by cleaning it. Cleaning the floor nozzle 51 Be sure to frequently clean the combination floor nozzle. Remove dust-balls, hair or other objects that may be entangled. Larger objects can be accessed by removing the connection tube from the nozzle. [. . . ] Let the cleaner cool down for 30 minutes before plugging it in again. If the cleaner still does not work, contact an authorized AEG-Electrolux service centre. Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorized AEG-Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. [. . . ]