User manual AEG-ELECTROLUX ARCTIS 70258 GS

[. . . ] Taste Alarm off Monter le support de poignée supérieur à la porte (3) et visser la barre de poignée au support depoignée inférieur. Vissez le support de poignée avec la barre de poignée tournée de 180° à la porte (5) et au support de poignée monté (6). Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. [. . . ] In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. These buttons are connected to the temperature display. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, , , B" or , , D". Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. The changed setting is immediately displayed on the temperature display. Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The following DESIRED temperature settings are possible: · Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps; If the buttons are not pressed again the temperature display will change after approx. The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the freezer (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the freezer temperature currently set (DESIRED temperature). Press the "I" button to stop the buzzer, the light still flashes since the temperatur is reached. The temperature display will immediately show the changed setting. each time the button is pressed the temperature is adjusted by 1 °C. From a food safety point of view -18 °C should be considered sufficiently cold for storing food in the freezer. [. . . ] Switch off the appliance by holding down the ON/OFF button. Remove the mains plug or switch off or turn out the circuit breaker or fuse. clean thoroughly (see section: "Cleaning and Care"). Leave the door open to avoid the build up of odours. [. . . ]