User manual AEG-ELECTROLUX ARCTIS1242-4

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle ands or with signal words (Warning!, Caution!, Attention!). This symbol guides you step by step in the operation of the appliance. [. . . ] Make sure that the side walls and the base of the appliance are not covered or obstructed. Appliance Alignment The appliance must have a solid, level footing. Please compensate for uneven floors with appropriate supports. Electrical Connection Warning ­ this appliance must be earthed Please ensure that the voltage and current indicated on the rating plate agree with the voltage of your electricity supply. If your appliance has been equipped with a mains lead with a moulded on type plug, you must comply with the following regulations: The plug moulded on to the cord incorporates a fuse. For replacement, use a 13 amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The fuse cover/carrier must be replaced in the event of changing the fuse. The plug must not be used if the fuse cover/carrier ist lost. A replacement cover/carrier must be obtained from an electrical goods retailer. If the socket outlets in your home are not suitable for the plug fitted to the appliance, then the plug must be cut off and an appropriate one fitted. When fitting the plug please note the following points: Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings indentifying the terminals in your plug, proceed as follows: 1. The wire which is coloured green and yellow must be connected to the earth terminal in your plug, which is marked with the letter E or by the earth symbol or coloured green, or green and yellow. Leave the lid open to prevent any smell from being formed. Conservation of frozen products Attention!Prior to loading the freezer the first time with food already frozen, the emperature of -18 °C necessary for safe storage should be obtained. - Store only frozen foods that are wrapped in order to prevent them becoming dry, loosing their flavour or interacting with the flavour of other frozen foods. - Observe the period storage recommended on pre-packed frozen food. - Store ice creams and high fat content foods in the lower part of freezer (near the bottom) 31 1 Fill the ice cube maker until Cup of the ice cube maker the cubes will be full in the horizontal position or by the Load line load line mark in the vertical position. After this close the ice cube maker with cap. Place it in the freezer and leave to solidify holder in the lid of the. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use a soft plastic scraper. Replacement of electric bulbs Warning!Prior to replacement of electric bulbs, remove the plug from the mains socket or disconnect or unscrew the fuse or lodgement. [. . . ] If it is quite normal for the freezer to seem warm on the outside occasionally, owing to the heat generated by the freezing process. This heat also helps to keep the appliance free In case os a power failure or breakdown Providing the period of power failure or breakdown does not exceed the temperature rise there will be no risk of damage to the frozen food, providing you do not open the lid during this period If the freezer is only half full or the lidid opened this will reduce the temperature rise time. 36 Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. [. . . ]