User manual AEG-ELECTROLUX ARCTIS2773-4GS

[. . . ] Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. If these instructions should not be sufficient, our customer service department is always available to you. The safety aspects of our refrigerators/freezers comply with accepted technical standards and the German Appliance Safety Law. [. . . ] The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance may not be connected to the mains. Remove the bottom hinge (E) by unscrewing the two fixing screws and keep the hinge gasket (x). slide the door off pin (G); unscrew pin (G) and refit it on the opposite side. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. With a wrench of 10 mm unscrew the pivot pin (z) of the hinge (e) and the rear screw (y); take from the accessory bag the lower cloG sing device left (m) and refit on opposite side of the same hinge by rescrewing the rear screw. take from the accessory bag the upper closing device (n) and refit on the opposite side of the upper trim rescrewing the screw. Refit bottom hinge (E) on the opposite side, using the two screws previously removed inserting the hinge gasket (x). Remove blanking cover (F) from ventilation grille (D) by pushing it in the direction of the arrow and refit it on the opposite side. Refit it on opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. Power cut) warning light (G) will start to flash and a buzzer will sound. After the temperature has returned to normal, the warning light (G) will continue to flash, although the buzzer has stopped. To switch off, hold down the ON/OFF button. Note: The appliance cannot be switched on or off if unplugged, or if there is no power being supplied to it. Following connection to the mains power supply, the appliance returns to the same operating state as before the interruption of main power. If the appliance is not going to be used for an extended period: Switch off the appliance, holding down the ON/OFF button until the display goes off (see above). Remove the mains plug or switch off or turn out the circuit breaker or fuse. defrost the freezer compartment and clean the appliance thoroughly (see section: "Cleaning and Maintenance"). Finally, leave the doors open so as to avoid a build up of odours. You can use your freezer for freezing fresh food yourself. [. . . ] Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. Do not place warm foods into the appliance. Do not set temperature any colder than necessary. [. . . ]