User manual AEG-ELECTROLUX AS3371-4GT

[. . . ] In order to avoid danger, if the connection lead of this appliance is damaged, it must be replaced by the manufacturer, its customer service department or a similarly qualified person. Repairs to the appliance may only be carried out by trained personnel. Contact the Electrolux customer service department or your dealer in the event of repairs being necessary. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] A spoon, knife or whisk) against the moving attachments and do not touch them with your hand. When you have finished working with the appliance, switch it off and unplug it from the electricity supply. Safety of children Never leave the appliance unattended when on and supervise particularly carefully if young children are around! Children should be supervised to ensure that they do not play with the appliance. Packaging material The packaging materials are environmentally friendly and can be recycled. Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. When using your appliance Never release the accessories while the processor/mixer is running. Ensure fingers are kept away from moving whisks and dough hooks. Stand Mixer 450 models are supplied with a stainless steel mixing bowl with lid. 0 To remove the accessories, hold firmly with one hand, while pressing the accessory release button (Figure 1/A). 0 Press the raise/lower button (Figure 1/F) and swing the mixer up or down, until it clicks in place. With the mixer raised, the accessories can be easily changed and the mixing bowl located on the processor stand or removed. Before fitting or removing the mixer, switch off the processor/mixer and remove the plug from the mains socket!0 To fit, push the mixer on to the processor stand (the two latches on the processor stand engage in the mixer) and press down to lock. 0 To remove, press the lock release (Figure 1/G) and pull the mixer upwards. It may be necessary to hold the base to prevent it rotating. The off-centre position of the mixer makes it easy to add ingredients while the processor is in operation. When the mixer is attached to the processor stand, the mixing bowl is automatically switched on when the mixer is switched on. The appliance can be used for up to 10 minutes without stopping. [. . . ] 0 The ON/OFF switch (Figure 1+6/B) is used to: ­ switch the mixer ON and OFF, ­ control the mixer speed (5 speed settings) in the pre-selected speed range. 0 As long as the Pulse button (Figure 1+6/D) is pressed and held when the appliance is in operation, the mixer operates at its maximum speed. 0 The mixing bowl speed selector switch (Figure 1/H) is used to select the mixing bowl speed: I = low speed II = high speed 0 Select the speed range with the speed range selector switch (Figure 1+6/C): low speeds, or high speeds. The following notes can be used as a guide. [. . . ]