User manual AEG-ELECTROLUX ASSISTENT FOOD PROCESSOR 7

[. . . ] Please read these operating instructions through carefully. Above all please follow the safety instructions on the first few pages of these operating instructions!Please keep the operating instructions for future reference. If applicable pass these instructions on to the next owner of the appliance. [. . . ] 1/D) can also be used as a filling beaker for this purpose. Close the filling inlet again immediately every time to avoid splashing. The insert holder must be fitted with the appropriate insert depending on the purpose of application (see "Inserting cutting insert in insert holder"). 8) mesh with the teeth underneath on the spindle. 4) The multifunction section can only be put into operation when the mix container is removed and the safety cover for the mixer drive (figs. 0 Place safety cover on mixer drive (mark on mark ) and turn counterclockwise to the stop. The mark must be above the warning lamp (fig. Preferably hold the insert holder with two fingers in the two handle holes. The nose of the cover is then directly above the handle, both black arrows must coincide. The all-purpose bowl can be heard to engage. They should be held only with the handle!Take required insert by the handle from the accessories compartment (fig. To remove the insert draw slightly outwards with the handle and raise. The following tools can be selected for insertion: Whisking disk (fig. The sieve insert can be heard to engage, arrow must coincide with arrow . Further ingredients can be added during operation through the filling inlet. the filling beaker in the stopper (fig. Close the filling inlet immediately each time to avoid splashes. It is recommended to start at a slow speed and then to increase the speed. 4/a) flashes and the appliance cannot be started, the safety cover for the mixer drive (figs. 0 Switch off appliance: turn speed selector left to the "0" position. 0 After using, turn cover clockwise and remove. [. . . ] Note: When processing sauces or semiliquid ingredients it may be necessary to switch off the appliance occasionally, to open the cover of the all-purpose bowl and scrape the mixture from the wall of the bowl with the scraper. Working with the insert holder Correct supply of the foods through the filling inlet is very important. Cut the prepared foods a little smaller if necessary, so that they pass easily through the filling inlet. The degree of pressure influences the concentration of the cut food. [. . . ]