User manual AEG-ELECTROLUX ASUPER1273-4G

[. . . ] 25 Insert the hose into the hose handle until the catches click to engage (press the catches to release the hose). ) (certain models have a lock button that must be pressed before the hose and telescopic tube can be pulled apart) 27 Pull out the power cord and connect it to the mains. Increase suction power by rotating the control further up to "Max" position. In order to achieve an optimal cyclone effect in the cleaner, the power regulation should always be in the "Max" position. [. . . ] Getting the best results Use nozzles as follows: Carpets and hardfloors: For carpets use the combination floor nozzle* with lever in position (32a) For Hard floors, use the combination floor nozzle with lever in position (32b). Make sure the brushes on the nozzle are down to prevent scratching the floor surface. Reduce suction power for short pile small carpets. With the Dust Magnet* nozzle there is normally no need to switch mode (33a). It can be used with brush up on all surfaces for maximum convenience with maintained excellent dust removal result. The (33b) brush setting should be used to reach optimal dust removal on difficult hard floors or to get a combing effect on carpets. Note: Do not use the turbo nozzle on animal skin rugs or carpet fringes. to avoid damaging the carpet , do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. The dust container must be emptied at the latest when it is filled to the MAX indication mark on the dust container. the dust container must never be over filled. In such cases, disconnect the mains and allow to cool down for 20-30 minutes. Clear blockage and/or replace filters, empty the dust container and restart Tubes and hoses 51 Use a cleaning strip or similar to clear the tubes and hose. 52 Hose handle can be dismantled from hose if cleaning is needed. 53 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to the hose caused by cleaning it. Cleaning the floor nozzle 54 Be sure to frequently clean the combination floor nozzle. Remove dust-balls, hair or other objects that may be entangled. Larger objects can be accessed by removing the connection tube from the nozzle. cleaning the turbo nozzle* 55 Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads , etc. Use the hose handle to clean the nozzle. [. . . ] Use the hose handle to clean the nozzle. 56 In case if the turbo nozzle stops working, open the cleaning lid and remove any objects that obstructs the turbine to rotate freely. 57 Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads , etc. Use the hose handle to clean the nozzle. [. . . ]