User manual AEG-ELECTROLUX AVQ2101

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!This symbol guides you step by step in the operation of the appliance. [. . . ] energy use and efficient performance of the appliance is affected by the ambient temperature. The appliance should therefore ­ not be exposed to direct sunlight; ­ not be installed next to radiators, cookers or other sources of heat; ­ only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: Climate classification SN N ST T for an ambient temperature of from + 10 at 32°C from + 16 at 32°C from + 18 at 38°C from + 18 at 43°C The temperatures of the hob, which in part are quite high, may damage the appliance. If a hob is installed near the appliance, the corresponding installation and safety instructions must be adhered to. Considering the numerous installation conditions which are possible, there is no way of providing detailed information here. It is necessary to avoid overheating of the appliance by maintaining adequate distances from heat sources and by the use of a suitable thermal insulation plate. Proper ventilation of the appliance must also be ensured. Please check whether, after installing your appliance and specially after rehingeing the door, the door seal seals right round. An untight door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. The supply must have a fuse rating of at least 10 Amps. This ensures safe and comfortable storage and removal of frozen products. To remove the drawers, proceed as follows: pull the drawer out until it comes to a stop, then tilt it upwards (see figure). The appliance should be installed well away from sources of heat such as stoves, radiators, etc. Keep door open only as much as necessary. Do not put hot foods or beverages in the appliance, allow them to cool down first. , · To thaw out frozen food, set it in the fridge. In this way frozen food cold temperature is exploited to keep the fridge cool. Clean the condenser and motor-driven compressor located on appliance rear panel using a brush or a vacuum cleaner. To quick-freeze foods when the appliance has not been in use, switch on the freezer and let it run on the quick-freeze setting for at least three hours before putting the food to be frozen in the compartment. If instead the appliance is already in operation, it should run on the quick-freeze setting for at least 24 hours before the food is put in the freezer. Once the food has been placed in the freezer, the freezing operation can be considered to be complete 24 hours later. [. . . ] Similar to all other liquids, refrigerant requires heat to evaporate. This heat is removed from the interior of the appliance, as a result the interior is cooled. The evaporator is therefore located inside the appliance or placed in foam immediately behind the inner wall and thus not visible. Compressor The compressor looks like a small drum. [. . . ]