User manual AEG-ELECTROLUX AVQ2115

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. and please pass it to any future owner of the appliance. [. . . ] It is necessary to avoid overheating of the refrigerator by maintaining adequate distances from heat sources and by the use of a suitable thermal insulation plate. Proper ventilation of the appliance must also be ensured. Your appliance needs air for safety reasons , minimum ventilationmust be as shown Fig. Attention: keep ventilation openings clear of obstruction; The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. Unscrew the lower pin and remove the spacer and refit them on the opposite side Refit the door, the upper pin and the spacer on the opposite side When changing the side at which the door opens, the appliance may not be connected to the mains. Penetration); Fix the square fitting to the appliance Slide the appliance into the recess, pushing it against the wall on the handle side. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). Fasten the appliance with 4 screws provided in the kit included with the appliance. Apply covers (C-D) on joint cover lugs and into hinge holes. Snap vent grille (B) and hinge cover (E) into position. During normal operation, the temperature currently present in the freezer (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the freezer temperature currently set (DESIRED temperature). Press the "I" button to stop the buzzer, the light still flashes since the temperatur is reached. The temperature display will immediately show the changed setting. each time the button is pressed the temperature is adjusted by 1 °C. From a food safety point of view -18 °C should be considered sufficiently cold for storing food in the freezer. There are two ice packs in one drawer of the freezer. In the event of a power failure or malfunction, the ice pack will lengthen the amount of time it takes for the frozen food to become too warm by several hours. The ice pack can only fulfil this task optimally if it is placed in the uppermost drawer, at the front, above the frozen food. You can use the ice pack for cooling cold bags. The FROSTMATIC function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. [. . . ] Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. Do not place warm foods into the appliance. Do not set temperature any colder than necessary. [. . . ]