User manual AEG-ELECTROLUX AW8550TFGVTC

[. . . ] 535055 0203 - MADE in ITALY Instructions Booklet X-FR X-GB Notice d'emploi et entretien GB GENERAL INFORMATION DESTINED TO THE END USER ENVIRONMENT PROTECTION Packing disposal Sort packing into different materials (cardboard, polystyrene etc. ) and dispose of them in accordance with local waste disposal laws. This appliance complies with the following European Directives: - 73/23/EEC regarding "Low Voltage". - 89/336/EEC regarding "Electromagnetic Disturbances". - 90/396/EEC regarding "Gas appliances" - 89/109/EEC regarding "Materials in contact with food" - Moreover the above mentioned Directives comply with Directive 93/68/EEC. [. . . ] The wire coloured brown must be connected to the terminal which is marked with letter 'L' or coloured red. The supply cable must not come into contact with any component the temperature of which exceeds the ambient temperature by 50°C. If a plug is used for connection, the plug to be connected to the supply cable and the socket to which it is connected must be of the same type (conforming to the standards). Easy access to the plug or the switch is ensured once the appliance is installed. Ensure that there is sufficient cable allowed for any subsequent removal of the unit. If the plug is non-rewireable, pay attention to the following points: the plug must never be cut by the supply cord. There is shock hazard when this plug is inserted in a socketoutlet elsewhere in the house. Never use the plug without the fuse cover fitted. Referring to the pertinent spare parts, apply to the appliance's supplier. The manufacturer declines all responsibility for any damage to persons or things caused by failure to observe the rules indicated above. Applance type All gas All gas + electric grill Supply single-phase 220-230 V~ Type of cable section Rubber H05 RR-F 3 x 0, 75 mm2 Rubber H05 RR-F 3 x 2, 5 mm2 H05 RR-F H05 RR-F 7 V VI VII V XI VI VII XII I II L III IV N 7 GB CARE AND MAINTENANCE INSTRUCTIONS DESTINED TO THE USER Before cleaning the appliance, disconnect the gas general tap and unplug the appliance or disconnect power at the main circuit breaker of the electrical system. Do not clean the appliance surfaces when still hot. OVERALL DIMENSIONS ENAMELLED SURFACES Clean with a damp sponge using soap and water. Grease can be easily removed using hot water or a specific cleansing agent for enamelled surfaces. Do not leave any acid or alkaline substances (lemon juice, vinegar, salt, etc. ) on the enamel. Clean the parts in stainless steel with specific cleansers for stainless steel surfaces. These detergents must be applied using a soft cloth. 1325 IMPORTANT Periodically check the external gas connection hole and replace it when it shows any sign of deterioration. Do not attempt to repair the gas hose under any cincumstances. 850 790 510 GRIDS AND BURNERS To clean the work-top burners, remove them by pulling upwards and soak them for about 10 minutes in hot water with a little detergent. After having cleaned and washed them, wipe them carefully. Make sure that no burner hole is clogged. Clean the burners once a week or more frequently if necessary. MAKE SURE YOU HAVE ASSEMBLED THE BURNERS IN A RIGHT WAY. OVEN DOOR For some models, the oven door can be disassembled in the following way: hinges A are provided, for this purpose, with two movable jumpers B; these, once hooked to the hinges slots C, when the door is completely opened, block them. [. . . ] Reassemble the protecting glass. B A E 14 25 W - 230 V~ T300°C H REGULATION OF AIR ADJUSTER (grill burner ) To do this, - To loosen the screw (A ) in order to approach or remove the regulator at the injector (fig M). In this way, entrace of the air increases or descreases, obtaining a correct flame. Be sure that the flame does not lift or light back or present a yellow colouration . A DISASSEMBLE OF WORK-TOP In case it is necessary to repair or replace the inside components, act as follows:remove the glass lid from its position slipping off it upwards. Remove the grids, remove burners and flame-spreaders (see fig. [. . . ]