User manual AEG-ELECTROLUX B533

[. . . ] Connecting to 12 Volt vehicle battery 9. 3. Connecting to LP bottled gas cylinder 9. 4. Connection of gas supply Environmental protection information Recycling 6. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. [. . . ] If the flame does not ignite, repeat the process. (Air in the appliance gas line prior to connection to the gas cylinder must be purged. Only then can the gas be lit. ) Ignition of the flame can be verified through the flameview opening (Figure 5). After you have the flame alight keep the safety gas valve pressed down for a further 10 seconds. Operating from LP bottled gas A E Figure 4. Figure 5. 6 6. Useful suggestions When setting out on a trip, run the appliance on 240 V for 24 hours prior to departure. Place food in a pre-cooled condition into the appliance. Frost forms on the evaporator panel when in operation. When opening the lid or putting in food, some of this frost melts and collects in the form of water on the bottom of the appliance. Wipe the water off occasionally using a sponge. Avoid putting foods with fragile packaging (such as glass) into the refrigeration unit. Movements and shaking of the unit may cause these items to break. Once the B533 is in its permanent position, make sure foods do not come into contact with the evaporator panel, as this can cause freezer-burn to the foods. The appliance is not operated on 12 Volts when your vehicle is parked, otherwise you will drain the battery in a short time. Only one power source is used at a time to run the appliance. 7. Defrosting, cleaning and maintenance For defrosting, always unplug the appliance from an electrical power source to avoid the risk of shock. Make sure no other power source is connected (gas or 12V). Remove food from the refrigeration unit and leave the lid open. Depending on the temperature, frost melts in a short time from the evaporator panel, with water collecting at the bottom of the appliance. Afterwards, clean the appliance by following the instructions in section 3. Leave the lid ajar to prevent any odours from forming. The appliance is serviced depending on use, at least once a year by an authorised service agent. 7 8. Trouble shooting Before calling a service technician please check carefully the operating instructions, service booklet and the warranty terms and conditions: Are location and ventilation satisfactory? [. . . ] Before attempting to light the burner, every time after connection, turn on the gas at the bottle and check the gas connections for leaks by applying a soap and water solution over them and watching for bubbles, which would indicate a leak. After testing dry off traces of detergent. Seal Figure 8. For your safety: Do not check for leaks with a naked flame! Do not smoke while checking for leaks! 10 10. Environmental protection information The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit. [. . . ]