User manual AEG-ELECTROLUX BP5004021M

[. . . ] Installation Environment concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Subject to change without notice 4 Safety information SAFETY INFORMATION Before the installation and use, read this manual carefully: · For your personal safety and the safety of your property · For the respect of the environment · For the correct operation of the appliance. Always keep these instructions with the appliance also if you move or sell it. The manufacturer is not responsible if incorrect installation or use results in damage. Children and vulnerable people safety · This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in safe way and understand the hazards involved. [. . . ] This function has no effect on the operation of the appliance. For changing the time of day refer to 'Setting the time of day'. You can use Duration and End at the same time (Time delay), if the appliance is to be activate and deactivate automatically later. To start the appliance with necessary settings with only one touch of the sensor field, any time later. SET+GO Count Up Timer Use the Count Up Timer to monitor how long the appliance operates. It is on immediately when the appliance starts to heat. Reset the Count Up Timer: touch again and again until flashes in the display. Touch until the display shows "00:00" and the Count Up Timer starts to count up again. You can not use Count Up Timer when Duration or End is set. Clock functions 15 Setting the DURATION 1. Activate the appliance and set an oven function and temperature. Touch again and again until the display shows . Use If you touch or during setting hours for DURATION, the appliance goes to setting of the END function. and "00" flash in the display. Use First you set seconds and then minutes and hours. When set time ends, an acoustic signal operates for two minutes and "00:00" and flash in the display. Touch any sensor field or open the oven door to stop an acoustic signal. AUTOMATIC PROGRAMMES WARNING!Refer to "Safety information" chapter. There are 20 automatic programmes and recipes. Use an automatic programme or recipe when you do not have a knowledge or experience how to prepare a dish. You can find the recipes for the automatic programmes in the "Recipe book". There are three types of automatic programmes: · Automatic recipes; · Automatic programmes with weight input; · Automatic programmes with core temperature sensor; Automatic recipes Setting an automatic recipe: 1. Touch two times until the display shows . The display shows symbol and number of the automatic programme. [. . . ] Refer to "Safety information" chapter. Problem The appliance does not heat up Possible cause The appliance is deactivated The time of day is not set. The necessary settings are not set Solution Activate the appliance Set the clock. Refer to "First setting the time of day" Make sure, the settings are correct The automatic switch-off is Refer to , , Automatic switch-off" activated The fuse is released Make sure, if the fuse is the cause for the malfunction. If the fuse releases again and again, refer to an authorized electrician Deactivate the "Demo" function. [. . . ]