User manual AEG-ELECTROLUX C100 VOXTEL

[. . . ] Plug the coiled handset cord into the handset. Plug the other end into the socket on the side of the base unit. Plug the telephone line cord into the phone line socket at the back of the base unit and the other end into your telephone line socket. Lift the handset and check for dial tone in the earpiece. [. . . ] 6 Mute Function During a call press the mute button . >When the mouthpiece is muted, the person at the other end of the call cannot hear you out you can hear his side. To get back to the call, press the mute button again. 7 Use on PBX If you are using your Voxtel C100 phone on a PBX, and the PBX user guide tells you to press recall or flash; Press the recall button on your phone. 8 Inserting a pause in the dialling sequence For some switchboard systems, an access number must be dialled (usually an 0 or 9) to get another dial tone and an outside line. Press the pause button immediately after the access number, a pause of about 3. 6 seconds will be entered, and the desired number can be dialled immediately. Note: If you use the , the pause will be included automatically. Press the pause button to insert a pause when storing numbers in memories, if a pause is required. 9 Storing a number in M1-M8 one-touch memories Lift up the handset, press the store button . Key in the telephone number you wish to store. Press one of the M1-M8 buttons to store the number in the selected memory. >If you try to store more than 32 digits, only the first 32 digits will be saved. 10 Storing a number in (0-9) two-touch memories Lift up the handset, press the store button . Key in the telephone number you wish to store. Press store button and then one of the 0-9 buttons to store the number in the selected memory location. Replace the handset on the base unit cradle. 11 Dial out a one-touch memory number for the selected number. Lift up the handset, press the M1-M8 button >The number dials automatically. 12 Dial out a (0-9) two-touch memory number To dial a number stored in a two-touch memory (0-9) Lift up the handset. Press the memory button Key in the memory location number (0-9) for the selected number. Warning: All one-touch, two-touch and redial memories will be erased if the phone is disconnected from the telephone line for longer than about 2 hours, and they will need to be stored again, if required. [. . . ] 10 CLEANING AND CARE Do not clean any part of your phone system with benzene, thinners or other solvent chemicals as this may cause permanent damage which is not covered by the Guarantee. When necessary, clean it with a damp cloth. Keep your phone system away from hot, humid conditions or strong sunlight, and don‘t let it get wet. 11 INTENDED USE This telephone is intended to be connected to a public analogue telephone network or to an analogue extension of an approved compatible PBX system. [. . . ]