User manual AEG-ELECTROLUX C67600K-MN

[. . . ] C67600K Ceramic glass induction hob Installation and Operating Instructions Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] Touch sensor fields + and - simultaneously to switch off or turn sensor field - back to zero. 3 A cooking zone may only be switched off when the decimal point is on in the cooking zone display. 60 Cooking with the Automatic Heating-Up Function All four cooking zones of the cooking field can be controlled in nine stages and have an automatic heating-up function: ­ 1, Lowest heat setting ­ 9, Highest heat setting ­ a, Heating-up function. With the automatic heating-up function (a), the cooking zone operates for a certain time at full capacity and then automatically switches back to the heat setting selected for further cooking. The duration of the automatic heating-up function depends on the heat setting selected for further cooking. Select the required cooking zone with the cooking zone sensor fields. The decimal point in the associated display field illuminates. 2. With the + or - sensor fields set the cooking stage 9. Stop briefly and touch the + sensor field again. 61 a lights up in the heat setting display. 3. Next, touch the sensor field - and set the required continued heat setting 1 to 8. The heat setting selected for further cooking is then displayed. 3 After 5 seconds, a appears in the display again instead of the heat setting selected for further cooking. The heat setting is displayed again after the heating-up time has ended. If you select a higher heat setting when the automatic function is in operation, e. g. from 3 to 5, the previous heating-up time is taken into account. If you select a lower setting, then the automatic function is brought to an immediate end. If you start cooking again on a cooking zone that is still warm, the automatic heating-up function uses the residual heat. This saves time and energy. 62 Cooking without the Automatic Heating-Up Function 1. For heating up/browning, select a high power. As soon as steam forms or the fat is hot, switch back to the required heat setting for the remainder of the cooking time. Note: When cooking with the induction cooking zone you should take into account that ­ the heating-up times are reduced by the direct energy transfer to the pan!­ the cooking process stops immediately after the cooking zone is switched off (no boiling over!) 2 Residual Heat Indicator When an individual cooking zone or the entire hob is switched off, any residual heat is shown with an h (for "Hot") in the digital display for the appropriate cooking zones. Even after the cooking zone has been switched off, the residual heat indicator only goes out when the cooking zone is cold. You can use the residual heat for melting and keeping food warm. As long as the residual heat indicator is illuminated, there is a risk of burns. [. . . ] The appliance also works perfectly on older networks with AC220V~. The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. [. . . ]