User manual AEG-ELECTROLUX C75301K-MN

[. . . ] C75301K Ceramic glass hob Installation and Operating Instructions Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. [. . . ] If you again wish to switch on a cooking zone on which hot items are already standing, you should always select the required heat setting with the - sensor field. In this way you can avoid making the food boil over as a result of the extra burst of heat from the automatic warm up. Cooking without the Automatic Warm up Function If you wish to use the cooking zone without automatic warm up, select the required heat setting with the - sensor field. Switch on the appliance and select the desired cooking zone using the cooking zone selection buttons. Touch sensor field - to select the required heat setting from ) to !. 3 You can adjust the heat setting at any time using the + and - buttons, providing the cooking zone has been selected. Select the desired cooking zone using the cooking zone buttons. Press the + and - buttons simultaneously to switch off. 1 When the rings are still hot cooking should be carried out without automatic warm up. 59 Operating Instructions Timer A cooking duration can be set with the integrated timer for all cooking zones. When the end of the cooking duration is reached, the cooking zone switches itself off automatically. Using the cooking zone sensor field, select the required cooking zone and set the required heat setting. Touch the TIMER W sensor field to activate the timer function for this cooking zone. Using the + or - sensor fields set or adjust the required period of time until the zone is to switch off automatically (eg. 15 minutes). After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up, e. g. the top left control indicator corresponds to the rear left cooking zone. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. 60 Operating Instructions 3 To set the timer more quickly, leave your finger on the + or - sensor field until the required time is reached. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("Minute Minder"). 3 Important!None of the cooking zones should be set with the Timer!Touch the "On/Off" sensor field for around two seconds. . Touch the TIMER W sensor field to activate the Timer function. Using the + or - sensor fields, set the desired length of time (for example, 20 minutes). The Timer begins to run after a few seconds, and indicates the time remaining. When the set time has elapsed, an audible signal is sounded. [. . . ] Additional silicon sealant must not be applied; this will make removal more difficult when servicing. · The hob must be pressed out from below when removed. 71 Installation Instructions Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The heating element voltage is AC230 V ~. [. . . ]