User manual AEG-ELECTROLUX C91900K-MNX05

[. . . ] 91900K Glaskeramik-Kochfeld Ceramic glass hob Table de cuisson vetrocéramique Glaskeramische kookplaat Montage- und Gebrauchsanweisung Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruikshandleiding Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] When the end of the cooking duration is reached, the cooking zone switches itself off automatically. Using the cooking zone sensor field, select the required cooking zone and set the required heat setting. Touch the TIMER W sensor field to activate the timer function for this cooking zone. Using the + or - sensor fields set or adjust the required period of time until the zone is to switch off automatically (eg. 15 minutes). After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. 56 3 To set the timer more quickly, leave your finger on the + or - sensor field until the required time is reached. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("Minute Minder"). 1 Important!None of the cooking zones should be set with the Timer! 1. Touch the "On/Off" sensor field for around two seconds. Touch the TIMER W sensor field to activate the Timer function. Using the + or - sensor fields, set the desired length of time (for example, 20 minutes). The Timer begins to run after a few seconds, and indicates the time remaining. When the set time has elapsed, an audible signal is sounded. Touch the TIMER W sensor field, to switch off the signal. Ending the timer function prematurely There are two ways of switching off the timer early: Switching off the cooking zone and timer simultaneously 1. Select the desired cooking zone using the cooking zone buttons. Touch the + and - buttons simultaneously: The cooking zone and timer will switch off. Switching off the timer - leaving the cooking zone active 1. Select the desired cooking zone using the cooking zone buttons. Touch the "Timer" button again. Touch the + and - buttons simultaneously: ­ Only the timer will switch off. [. . . ] The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. The connection must be carried out as shown in the diagram. [. . . ]