User manual AEG-ELECTROLUX C9500G-CMIE

[. . . ] x GB x FR INSTRUCTIONS BOOKLET NOTICE D'EMPLOI ET ENTRETIEN - MADE IN ITALY tip. 535017 1003 mod. GB GENERAL INFORMATION DESTINED TO THE END USER ENVIRONMENT PROTECTION Packing disposal Sort packing into different materials (cardboard, polystyrene etc. ) and dispose of them in accordance with local waste disposal laws. RECCOMANDATIONS AND PRECAUTIONS ATTENTION: - Before using the appliance, do not forget to remove the plastic films protecting some parts of the appliance (facia-panel, parts in stainless steel, etc. ) - Do not use the appliance as a space heater. - When the appliance is not in use, we recommend to disconnect the current and to close the gas general tap. This appliance complies with the following European Directives: - 73/23/EEC regarding "Low Voltage". - 89/336/EEC regarding "Electromagnetic Disturbances". [. . . ] This function remains activated 7 seconds after the last +/operation. Timer setting This function is permanently activated and it will be immediately set with +/- buttons. During setting the units are 10 seconds. During count down the timer takes priority on the display. The relay contact (when available) is closed during the count down only. Reset timer Press "+" and "-" buttons together and release "+" button first. Signal The signal after time out will stay 7 minutes if it has not been reset with the "+" button (one touch only). Signal frequency When the display shows the time of day, the signal frequency can be selected by pressing the "-" button. Three different frequencies are selectable. This appliance must be earthed by law. Before connecting the appliance to the electrical supply, check that the earth system in your house is working correctly. Check that unit voltage and power, marked on the rating plate applied on the appliance, are correct for the supply. It is necessary that the feeding network is protected by a powerful switch able to disconnect completely the network with a contacts separation of at least 3 mm. Be sure that the earth wire green/yellow is not interrupted by the switch. Important: The wires in the mains lead are so coloured: - green/yellow = earth " " - blue = neutral "N" - brown = live "L" The wire coloured green/yellow must be connected to the terminal in the plug which is marked with letter 'E' or by the earth symbol or coloured green or green/yellow. The wire coloured blue must be connected to the terminal which is marked with letter 'N' or coloured black. The wire coloured brown must be connected to the terminal which is marked with letter 'L' or coloured red. The supply cable must not come into contact with any component the temperature of which exceeds the ambient temperature by 50°C. If a plug is used for connection, the plug to be connected to the supply cable and the socket to which it is connected must be of the same type (conforming to the standards). Easy access to the plug or the switch is ensured once the appliance is installed. Ensure that there is sufficient cable allowed for any subsequent removal of the unit. If the plug is non-rewireable, pay attention to the following points: the plug must never be cut by the supply cord. There is shock hazard when this plug is inserted in a socket-outlet elsewhere in the house. [. . . ] Remove the grids, remove burners and flame-spreaders (see fig. 13), unscrew the visible screws "V" placed on the work-top (see fig. Disassemble the work-top by unscrewing the 4 rear screws "A" (see fig. 14 REGULATION AIR ADJUSTER REGULATION OF AIR ADJUSTER (oven burner ) To do this, - Unscrews the screw (A ) in order to rotate the metal ring at the end of the burner (fig L ). [. . . ]