User manual AEG-ELECTROLUX C9500G-MM

[. . . ] GB GENERAL INFORMATION DESTINED TO THE END USER ENVIRONMENT PROTECTION Packing disposal Sort packing into different materials (cardboard, polystyrene etc. ) and dispose of them in accordance with local waste disposal laws. RECCOMANDATIONS AND PRECAUTIONS FIRST PART ATTENTION: - Before using the appliance, do not forget to remove the plastic films protecting some parts of the appliance (facia-panel, parts in stainless steel, etc. ) - Do not use the appliance as a space heater. - When the appliance is not in use, we recommend to disconnect the current and to close the gas general tap. This appliance complies with the following European Directives: - 73/23/EEC regarding "Low Voltage". - 89/336/EEC regarding "Electromagnetic Disturbances". - 90/396/EEC regarding "Gas appliances" - 89/109/EEC regarding "Materials in contact with food" - Moreover the above mentioned Directives comply with Directive 93/68/EEC. [. . . ] Remove the grids, remove burners and flame-spreaders (see fig. 13), unscrew the visible screws "V" placed on the work-top (see fig. Disassemble the work-top by unscrewing the 4 rear screws "A" (see fig. 8 GAS CONNECTING Gas Connection Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating plate which can be found on the back cover. This appliance is not designed to be connected to a combustion products evacuation device. Particular attention should be given to the relevant requirements regarding ventilation. Connection to the cooker should be made with an approved appliance flexible connection to local rules. Models for use with LPG should be fitted with a hose suitable for LPG and capable of withstanding 50mbar pressure. A length of 0. 9 to 1. 25m is recommended. The length of hose chosen should be such that when the cooker is in situ, the hose does not touch the floor. The temperature rise of areas at the rear of the cooker that are likely to come in contact with the flexible hose do not exceed 700C. Gas pressure may be checked on a semi-rapid hob burner. Remove the appropriate injector and attach a test nipple. Light the other burners and observe that the gas pressure complies with the gas standards in force. Certain types of cookers can be set for sypply both on the right and lefthand side. In this case it is sufficient to reverse the position of the cad nipple reducer. At the end make sure than there is no leakage of gas. The grill must be used with the door half-open (see fig. 2 A). Fit the deflector S onto the centring pins N on the top of the oven opening (fig. 2 B ). Then gently close the oven door against the deflector. Some models are designed for the grill to be used with the oven door completely closed. Make sure that the cooker is designed for this type of operation. [. . . ] Manual V VI connection: turn knob B to position I a without pressing it in. GRIDS AND BURNERS To clean the work-top burners, remove them by pulling upwards and soak them for about 10 minutes in hot water with a little detergent. After having cleaned and washed them, wipe them carefully. Make sure that no burner hole is clogged. Clean the burners once a week or more frequently if necessary. [. . . ]