User manual AEG-ELECTROLUX CALLISTO Z8215

[. . . ] More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 countries around the world. PN. 00 (04/04) E. H. MAC 540E - MAC 542E MAC 538E - MAC 539E California - MAC 545E P 540E - P 542E P 538E - Euromac S42 Euromac S43 Euromac S44 Titanium 460 14" 50T 350mm 3/8" GB Promac 40 II Promac 46 II P 461 II DE FR NL X (5/32") NO FI SE DK Due to a constant product improvement programme, the factory reserves the right to modify technical details mentioned in this manual without prior notice. Im Sinne des Fortschritts behält sich der Hersteller das Recht vor, technische Änderungen ohne vorherigen Hinweis durchzuführen. [. . . ] Fuel mix Do not use any other type of fuel than the type recommended in this manual. This product is equipped with a two-stroke engine and must therefore use a mixture of lead-free gasoline (with a minimum of 90 octanes) and fully synthetic oil for two-stroke engines, specific for lead-free gasoline in the proportions indicated in the table on the cover page at item (D). Read the oil specifications on the can carefully: the use of oil lacking the specifications indicated in this manual can cause severe damage to the engine!To obtain the best mixture, pour the oil first, followed by the gasoline, into an approved container, shake well (repeat the operation every time you draw any fuel from the container). The characteristics of the mixture are subject to aging and may be altered in time, so we recommend mixing only the amount strictly needed for use. If you use a mixture that is several weeks old, this could damage the engine. Re-fuel in open spaces only, keeping away from naked flames or sparks. Always store fuel in an approved container. SAFE STORAGE OF FUEL Petrol is highly inflammable. Put out all cigarettes, pipes and cigars before working with petrol. Store fuel in a cool, well ventilated place, in an approved container specifically designed for the purpose. Pull the starter rope until the engine starts. Allow engine to warm up for ten seconds for better cutting performance. Squeeze the throttle trigger (G) to release the throttle advance. If engine fails to start, repeat these instructions. 6 The engine is stopped by depressing the STOP switch to STOP position. After lengthy use of the chain at full speed, we recommend to run the engine for a few seconds at idle speed before stopping it. STARTING A WARM ENGINE Check that the ignition switch is not in the "stop" position and do not use the throttle lock. Hold the saw firmly, press valve (D) for decompression and pull the starter rope. STARTING A WARM ENGINE AFTER RE-FUELLING In the fuel tank as run completely dry, procede to start as with a cold engine. F. The carburetor has three adjustment screws: ENGLISH - 4 · L: The needle screw L governs the fuel flow at low speed and also the acceleration from low to full speed. To set screw L: close screw L turning it clockwise without forcing. Then open screw 1 full turn (counterclockwise) . [. . . ] Therefore you should avoid starting a cut with this part of the bar. Always keep a firm grip on the saw with both hands because, in case of kickback, it is the contact of the left hand with the brake lever which will help to engage the brake. CHAIN BRAKE TESTING: 1 The chain brake (A) is disengaged when brake lever is pulled back and locked(chain can move). 2 The chain brake (A) is engaged when brake lever is in the position (chain cannot rotate). [. . . ]