User manual AEG-ELECTROLUX CB425GL4+

[. . . ] This freezer should only be operated by adults. Children must not be allowed to tamper with the control buttons or play with the freezer. Changes in the electrical mains system in connection with the installation of this freezer should always be carried out by an authorised electrician or competent person. Do not under any circumstances attempt to repair the freezer yourself. [. . . ] Before disposing of an old freezer, make sure that the lock (if present) no longer works. This is to prevent accidents and avoid the danger of children getting locked inside. IN THE INTERESTS OF THE ENVIRONMENT: When disposing of your old fridge, freezer or fridge/freezer: Check with your local Council or Environmental Health Officer to see if there are facilities in your area for collecting the gas from the appliance for recycling. This will help reduce the amount of CFC gas released into the atmosphere. Help to keep your country tidy - when disposing of an old appliance or a CFC free appliance use an authorised disposal site. INSTALLATION POSITION Place the freezer horizontally on a firm surface, resting on all four wheels. The room should be dry and adequately ventilated. If the room temperature exceeds 32°C, or falls below 10°C, the freezer will not function as it should. Do not place the freezer close to sources of heat, radiators, chimneys, etc. , and do not place the freezer in direct sunlight. If the freezer has been handled standing on end it should be allowed to stand in normal position for about 12 hours before switching it on Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. ELECTRICAL REQUIREMENTS Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate, located on the backside of the appliance. WARNING: This appliance must be earthed. SWITCHING ON Before switching on, the freezer should be cleaned inside. WARNING: The enclosed wheels must be fitted before switching on the freezer. Do not use the appliance without the wheels because it may result malfunction. Allow the freezer to run for several hours before placing food inside. 4 INSTALLATION FITTING WHEELS The wheels are fitted as shown in the drawing, using the enclosed fitting key. If the freezer is equipped with wheels with brake, you can brake the freezer by pushing the brake down and you can loosen it by pushing it up as shown in the figure. To ensure the stabilization of the freezer you have to brake two wheels at the same time. 5 HOW TO USE PACKAGING AND POSITIONING Food must be frozen before placing into the freezer. Food must be packed in airtight and moisture-proof packaging to pevent it from drying out. Never fill the freezer above the load line" mark (see on the figure) which can be found on the innerside of the appliance. TEMPERATURE CONTROL The thermostat ensures that the required temperature is maintained in the freezer. Adjust the temperature by turning the button with a coin that fits the groove. Turning the thermostat button towards no. 7 makes the temperature in the freezer colder, and turning the button towards no. The correct setting can be found by measuring the temperature of the top package in the middle of the freezer. This should not have a temperature higher than -18°C. The thermostat has been adjusted to the optimal position by the manufacturer. Please do not adjust the thermostat unless the temperature is permanently higher than -18 °C. Before adjusting the temperature please disconnect the appliance from the electricity supply and remove the plastic grid from the right side of the freezer. [. . . ] The defrost water can be collected in a bowl as shown in the drawing. HOW TO CLEAN YOUR FREEZER INSIDE Remove the plug from the mains socket, and remove all loose accessories before cleaning the freezer. The best time to clean your freezer is after defrosting and before the electricity supply is connected again. Use hot water, and a mild, non-aromatic cleaning agent. After cleaning the freezer, clean the basket/baskets before replacing them. [. . . ]