User manual AEG-ELECTROLUX CG6200

[. . . ] 53 17 Problems that can be resolved before calling the Customer Service Centre 18 Technical Data 19 Disposal 20 If service is needed 10 Frothing milk 10. 1 Cleaning the steam nozzle 11 Preparing hot water 12 Setting the grinding texture 54 56 56 57 33 g 1 1. 1 A B C D E F G H J K L M N Figure captions 1. 2 Front view (Fig. 1) P Drip grid Q Thermos jug R Main switch (rear side of appliance) S Height-adjustable coffee dispenser T Control panel (see Fig. 3) U Bean container lid V Pre-ground coffee lid W Heated cup rack X Swivel pipe for steam and hot water Y Steam nozzle (removable) Z Inner part of steam nozzle (removable) Service door opening button 1. 3 Water tank with max. fill level indicaa tion (removable) O Drip tray with float (removable) b c d e Front view with open service door (Fig. [. . . ] Remove foreign objects from the grinder Foreign objects such as small stones in the grinder can damage the grinder. A foreign objects in the coffee causes a loud, regular rattle. If you hear this noise while coffee is being ground, immediately switch off the coffee machine and call the Customer Service Centre. 1 Caution!Danger of scalding when the hot water nozzle is activated!Hot water or steam output can cause scalding. Activate the hot water nozzle only when a container is under the hot water nozzle. 0 Place a container under the hot water nozzle. 0 Turn the knob for steam and hot water to the position (Fig. Hot water is dispensed; the display shows «HOT WATER». 3 You should not run off hot water for 13 more than two minutes at a time. 0 After you have dispensed the hot water 13. 1 turn the knob for steam and hot water back to the position (Fig. 10) and remove the container. 3 Menu settings Setting the language You can choose between several languages. The display shows the current setting, e. g. Where necessary, select a different temperature, using the scrolling keys "<" or ">" (Fig. When the required temperature is indicated, confirm this with the "OK" key (Fig. If "OK" is not pressed, after about 120 sec. the appliance returns automatically to the coffee mode without storing the setting. 0 The factory setting is «AUTO SHUTOFF TIME 1 H». You can change this setting as follows: Press the "Menu" key (Fig. The menu item «CHOOSE LANGUAGE» appears. Press the scrolling keys "<" or ">" (Fig. 5) until the menu item «AUTO SHUTOFF TIME» appears. Confirm the menu item with the "OK" key (Fig. [. . . ] The tilt compartment (R) inside the service door is blocked and cannot swing. Thoroughly clean the tilt compartment, particularly near the hinges, to ensure they are free to swing smoothly. Ground coffee was used (not beans) and the appliance does not deliver any coffee Too much ground coffee has been added. Remove the brewing unit and thoroughly clean the inside of the appliance, as described in , , Cleaning the brewing unit", page 51. [. . . ]