User manual AEG-ELECTROLUX CG6600 (WEST)

[. . . ] Customer g Dear read this user manual carefully, Please Paying special attention to the safety notes!Keep the manual in a safe place for later reference, and pass it on to any new owner. Key to picture 38 Front view (Figure 1) 38 Milk container (Figure 2) 38 Front view with open service door (Figure 3) 38 1. 8 Looking up the number of coffees dispensed, number of jugs dispensed and number of descaling procedures (statistics) 54 13. [. . . ] The coffee temperature levels are defined as follows: «TEMPERATURE LOW» «TEMPERATURE MEDIUM» «TEMPERATURE HIGH» The factory setting is «TEMPERATURE HIGH». You can change this as follows: 0 Press the "MENU" button (Figure 5). 0 If necessary, select another temperature with the scrolling buttons "<" or ">" (Figure 6). 0 If necessary, select another switch-off time with the scrolling buttons "<" or ">" (Figure 6). If "OK" is not pressed, the appliance automatically returns to the coffee mode after about 120 seconds without saving the entries. The display automatically jumps back to the menu option «AUTO SHUTOFF TIME» after programming. To go back to the coffee mode, press the "MENU" button (Figure 5) or wait about 120 seconds until the appliance automatically jumps back to coffee mode. If "OK" is not pressed, the appliance 3 automatically returns to the coffee mode after about 120 seconds without saving the entries. 0 The display automatically jumps back to the menu option «TEMPERATURE» after programming. 0 To go back to the coffee mode, press 13. 4 the "MENU" button (Figure 5)or wait about 120 seconds until the appliance automatically jumps back to coffee mode. You can adjust and change this to suit your taste. The coffee strength can be adjusted in 5 steps from extra mild to extra strong and the filling quantity can be adjusted in 10 steps with the aid of a graphic bar. You can change these settings as follows: Press the "MENU" button (Figure 5). If necessary select a different coffee strength in 5 steps from extra mild to If the appliance is not used for a while it switches itself off automatically for safety and energy saving reasons. You can choose between 3 switch-off times (automatic switch-off after 1 to 3 hours): «AUTO SHUTOFF TIME 1 H» «AUTO SHUTOFF TIME 2 H» «AUTO SHUTOFF TIME 3 H» The factory setting is «AUTO SHUTOFF TIME 1 H». You can change this as follows: 0 Press the "MENU" button (Figure 5). 0 When the desired coffee strength is displayed, confirm it with the"OK" button (Figure 6). This coffee strength is programmed in accordingly. If "OK" is not pressed, the appliance automatically returns to the coffee mode after about 120 seconds without saving the entries. The display automatically jumps back to the menu option «JUG COFFEE TASTE» after programming. 0 If you want to change and save the filling quantity for the jug, press thescrolling button ">" (Figure 5) until the menu option «JUG OR CUP LEVEL» appears. [. . . ] Coffee does not come out of the spouts on the coffee dispenser but out of the service door at the side The holes on the coffee dispenser are blocked with dried on coffee. remove the dried on coffee with a needle (Figure 34). The swing drawer (Q) on the inside of the service hatch is blocked and will not move. Carefully clean the swing drawer, particulary in the area around the hinges so that these continue to move. [. . . ]