User manual AEG-ELECTROLUX CK155

[. . . ] To connect the pipe fit the coupling ring "C" in the outlet selected. Use cover "D" to close the unused outlet (fig. Important: When using the rear exhaust outlet open the hole on the conveyor by pulling the tabs E (fig. [. . . ] Important: When using the rear exhaust outlet open the hole on the conveyor by pulling the tabs E (fig. -- Make holes at the bottom of the cabinet using the template supplied -- Fit the 4 4. 2x35 screws supplied, from inside the cabinet in the holes on the appliance (fig. 7). Fixing to the cabinet The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because cooking oil could flare up. -- The hood must not be connected to fuel exhaust flues (boilers, heating systems, water heaters, etc). -- The manufacturers refuse liability for damage to the hood or its catching on fire because of failure to observe the above instructions. -- replace every 3/4 months for normal use Dismounting the filter: -- rotate in anti-clockwise direction Rectangular filter: -- replace every 6/8 months Dismounting the filter: -- push the stops N in and pull the filter down (fig. 6). Attention Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Grid Opening -- Open the latch L and rotate the grid downwards (fig. 9) -- To remove, pull forward from the right hand side and unhook. Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. -- Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Internal recycle system (filtering) The air is recycled into the room through the front grid. Cleaning Using the hood It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. On the front part of the appliance there are the control switches, which change according to the type of hood (see electrical sketches enclosed) . Lever F: in position F (fig. There are two carbon filter models available: -- Circular: with bayonet attachment -- rotate in clockwise direction (fig. -- Rectangular: fits on the frame G and snaps into place on the conveyor (fig. 6) To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Never use products containing abrasives. This appliance meets 87/308 EWG radio and television noise standards. Installation When installed. In the vented exhaust version the fumes outlet duct must be 100-120 mm. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. Attention -- If the hood is run at the same time as an ambient-air dependent burner or fireplace (for example gas, diesel, coal or wood heaters, water heaters, etc. ), be careful, because the hood, when it exhausts the air, removes the ambient air the burners or fireplace need for combustion. [. . . ] In the vented exhaust version the fumes outlet duct must be 100-120 mm. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. Attention -- If the hood is run at the same time as an ambient-air dependent burner or fireplace (for example gas, diesel, coal or wood heaters, water heaters, etc. ), be careful, because the hood, when it exhausts the air, removes the ambient air the burners or fireplace need for combustion. For safe operation and to prevent discharged gas from coming back into the room, make sure there is an air inlet . which may be provided through air-recycling doors, windows or wall boxes or by other technical devices. [. . . ]