User manual AEG-ELECTROLUX CK1610

[. . . ] A non-return fume valve is available as an optional. 4) Fixing to the cabinet -- Make holes at the bottom of the cabinet using the template supplied -- Fit the 4 4. 2x35 screws supplied, from inside the cabinet in the holes on the appliance (fig. 7). The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. [. . . ] When frying foods, never leave the pan alone because cooking oil could flare up. -- The hood must not be connected to fuel exhaust flues (boilers, heating systems, water heaters, etc). -- The manufacturers refuse liability for damage to the hood or its catching on fire because of failure to observe the above instructions. -- replace every 3/4 months for normal use Dismounting the filter: -- rotate in anti-clockwise direction Rectangular filter: -- replace every 6/8 months Dismounting the filter: -- push the stops N in and pull the filter down (fig. 6). Attention Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Grid Opening -- Open the latch L and rotate the grid downwards (fig. 9) -- To remove, pull forward from the right hand side and unhook. Changing the bulbs -- Disconnect the hood from the electricity. -- Always replace burn-out bulbs with olive-shaped max 40 Watt (E14) bulbs. To dismount the filter, open the grid and remove stop M (fig. 9). Internal recycle system (filtering) The air is recycled into the room through the front grid. There are two carbon filter models available: -- Circular: with bayonet attachment -- rotate in clockwise direction (fig. -- Rectangular: fits on the frame G and snaps into place on the conveyor (fig. 6) Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Never use products containing abrasives. This appliance meets 87/308 EWG radio and television noise standards. Using the hood It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. [. . . ] Never use products containing abrasives. This appliance meets 87/308 EWG radio and television noise standards. Using the hood It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. On the front part of the appliance there are the control switches, which change according to the type of hood (see electrical sketches enclosed) . Installation When installed. [. . . ]