User manual AEG-ELECTROLUX CK1610WS-D

[. . . ] To connect the pipe fit the coupling ring "C" in the outlet selected. Use cover "D" to close the unused outlet (fig. [. . . ] 2 on H, and 1 hole on any of points I, as required. -- Fit 3 0, 8 mm wall plugs -- Fit 2 5x45 screws on H--do not tighten completely -- Now hang the hood (holes H). Tighten the 2 screws and fit the third 5x45 screw in hole I from inside the cabinet (fig. 8). Grease filter The grease filter traps the suspended grease particles. It is installed in the exhaust grate and is available in four different versions: synthetic, thin synthetic with saturation indicator, thin synthetic without saturation indicator, and metal. 1) The synthetic filter (thickness about 12-15 mm) in normal use is washed once a month and replaced after 5 or 6 washinings. Wash it in warm water a biodegradable detergent. 2) The thin synthetic filter (thickness about 1 mm. ), is changed when the top coloring appears on the bottom. 3) The tin synthetic filter (thickness about 1 mm. ) without saturation indicator is replaced every two months with normal use. 4) The life of the metal filter is practically unlimited and should be washed the same as the synthetic filter once a month and allowed to dry before reinstalling It. [. . . ] In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. Attention -- If the hood is run at the same time as an ambient-air dependent burner or fireplace (for example gas, diesel, coal or wood heaters, water heaters, etc. ), be careful, because the hood, when it exhausts the air, removes the ambient air the burners or fireplace need for combustion. For safe operation and to prevent discharged gas from coming back into the room, make sure there is an air inlet . which may be provided through air-recycling doors, windows or wall boxes or by other technical devices. [. . . ]