User manual AEG-ELECTROLUX CK460

[. . . ] Cooker Hood USER MANUAL CK 450, CK 460, CK 470, CK 480 821 27 08-01/4 Fläkten är tillverkad i moduler så att endast små detaljer behöver bytas vid eventuell service. Ventilatoren er bygget opp av moduler slik at det kun er nødvendig å bytte små detaljer ved eventuelt behov for service. Emhætten er frem stillet i moduler, så de enkelte del kan udskiftes ved hætter evt. service. SERVICE Liesituuletin on moduulirakenteinen siten, että huollon yhteydessä pitää vaihtaa vain pieniä osia. [. . . ] Mounting set: 4 pcs 4x60 mm screws, 4 pcs 5x30 mm screws, 4 pcs M5x30 mm screws, 4 pcs 5, 3x15 mm washers, 4 pcs 5, 3x10 mm washers, 4 pcs M5 mm nuts, 4 pcs spacers, 4 pcs 10 mm wall dowels, 4 pcs locknuts, 4 pcs plastic covers, 2 pcs brackets. Following is ordered from retailer: Venting kit: When the cooker hood is to be connected to an evacuation channel use the venting kit containing one ventilation pipe, one roof connecting metal flange and two clamps. LONG LIFE carbon filter: The carbon filter is to be used when the hood is connected to the recirculation system. For new installations: PNC 391 834 201 (50 cm), 391 834 200 (60/70 cm). 3 years): PNC 391 837 001 (50 cm), 391 837 000 (60/70 cm). Venting grid: Venting grid for recirculation. PNC 391 433 101. Functions There are two possible systems: Extraction of air to outside using optional venting kit and evacuation duct. Recirculation using optional carbon filter. The cooker hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please, keep to the provisions of official directives regarding the question of fumes discharge. When you use the carbon filter, the air is purified within the cooker hood and recirculated back into the room, so heated air is not lost. It can be a good idea to use the carbon filter in winter and normal air extraction to a duct in summer. 32 Using the cooker hood The control panel The control panel is under the cooker hood. Best results are obtained by using low speed for normal conditions and high speed when smells and steam are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all steam and smells have disappeared. Do not operate the fan at a higher speed than necessary. The low speeds are adequate for ordinary requirements while cooking. The high speeds should be used only if food has burnt while cooking, or for other strong fumes. Correct ventilation If the cooker hood should be working correctly there must be an underpressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. Important to know Great care must be taken if the hood is used at the same time as a burner or fireplace (e. g. gas, diesel, coal or wood heaters, water heaters, etc. ), as the hood will expel air which is required by these other appliances. Not applicable for cooker hoods used in recirculation mode. Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. The grease that collects in the filter and the duct could ignite if a hot plate is left on (or if overheating occurs). Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. [. . . ] Remember to save your purchase receipt and warranty card (only used in some countries). Service and spare parts Your dealer or service company will supply you with service and spare parts. Be sure you have the product number and model name at hand when ordering service or parts. 34 Technical data Model Airflow Size Light Grease filter Voltage Total power Max. Height Width Depth CK 450 320 m ³/h x) 180 m ³/h 160 m ³/h 45 mm 498 mm 445 mm Max 11 W PL 1 pc. 230 V 111 W CK 460 320 m ³/h x) 180 m ³/h 160 m ³/h 45 mm 598 mm 445 mm Max 11 W PL 1 pc. [. . . ]