User manual AEG-ELECTROLUX CS114D

[. . . ] Voltage . . . . . . . 25 Wall Installation Please follow these installation instructions: For best performance, air needs to circulate freely over the cooling unit behind the wine cellar. The freestanding design of the cellar means that it should stand at least 25 mm from the rear and side walls. Allow a clearance of at least 100 mm above the wine cellar. Adjust the feet of the wine cellar so that it stands in a vertical position in both directions. [. . . ] Please check that the voltage shown on the data plate corresponds to your power supply. WARNING THE WINE CELLAR MUST BE EARTHED. The wine cellar is fitted with a plug intended for an earthed socket. Electrolux and its subsidiaries will not be held responsible for any incident due to nonexistent or defective earth wires. Electrical leads must be routed and secured so that they cannot come into contact with hot or sharp parts of the wine cellar. Plug in the wine cellar and turn it on with the S1 switch (see fig. 3). We recommend that you keep your wine cellar as clean as possible. Do not use any abrasive substances, cleaning products or sponges. It is very important to check regularly that the air circulation underneath and behind the cellar is not blocked. Condensation collects in a small cup inside the cellar at the back. The cup has a sponge which helps the condensation to evaporate. Check that the plastic pipe routing the water from the inside to the cup is not blocked by dust or dirt. You should replace the inside ventilation charcoal filter every second year. The filter is fitted in an upper corner of the wine cellar. Loading the wine cellar. Temperature setting Please see illustrations in fig. Bottles should be stored in your wine cellar according to their size. The best known bottles are the Bordeaux and the Burgundy. The most widely recognised bottles are the Tradition and the Légère. The Champenoise and the flûte dAlsace bottles have different diameters and heights. Take these differences into account when storing your wine and avoid mixing the bottles. It is important to store bottles on their side in order for the cork to remain in contact with the wine. [. . . ] Message L1 will appear and the pre-set temperature is then shown shortly afterwards. Use buttons [2] and [3] to lower or increase the temperature. Please allow 6 seconds for the control system to record the new pre-set value. It is important to avoid rapid temperature changes inside your wine cellar. 7 It is possible to add more sliding or storage shelves to your wine cellar. [. . . ]