User manual AEG-ELECTROLUX CS200DV

[. . . ] Voltage . . . . . . . 25 Wall Installation Please follow these installation instructions: For best performance, air needs to circulate freely over the cooling unit behind the wine cellar. The freestanding design of the cellar means that it should stand at least 25 mm from the rear and side walls. Allow a clearance of at least 100 mm above the wine cellar. Adjust the feet of the wine cellar so that it stands in a vertical position in both directions. [. . . ] Please check that the voltage shown on the data plate corresponds to your power supply. WARNING THE WINE CELLAR MUST BE EARTHED. The wine cellar is fitted with a plug intended for an earthed socket. Electrolux and its subsidiaries will not be held responsible for any incident due to nonexistent or defective earth wires. Electrical leads must be routed and secured so that they cannot come into contact with hot or sharp parts of the wine cellar. Plug in the wine cellar and turn it on with the S1 switch (see fig. 3). We recommend that you keep your wine cellar as clean as possible. Do not use any abrasive substances, cleaning products or sponges. It is very important to check regularly that the air circulation underneath and behind the cellar is not blocked. Condensation collects in a small cup inside the cellar at the back. The cup has a sponge which helps the condensation to evaporate. Check that the plastic pipe routing the water from the inside to the cup is not blocked by dust or dirt. You should replace the inside ventilation charcoal filter every second year. The filter is fitted in an upper corner of the wine cellar. If the wine cellar fails to work, check the following points before calling a service technician: that the fuse is intact that the mains plug is properly inserted in its socket that the wine cellar is switched on If the cause of failure is not to be found among the points listed above, an authorised service technician must be called for. The wine cellar is equipped with overheating protection. An authorised service technician can check whether these have been triggered or not. Temperature setting (see fig. 3) The wine cellar is equipped with an electronic regulator. This allows you to programme the temperature inside the wine cellar. Your wine will then be stored between 10°C and 15°C according to expert advice. The temperature is shown on the display. The temperature, [pre-set at 12°C], can be changed according to the wine stored. [. . . ] Our illustrations show the best way to stack the Burgundy and the Bordeaux Tradition. 7 Note that you should store no more than one layer of bottles on the sliding shelves. The sliding shelves and the storage shelves can be placed in several positions depending on the size of your wine cellar. Please note that the rear holes are used for both the storage shelf support and the sliding shelf. It is possible to add more sliding or storage shelves to your wine cellar. [. . . ]