User manual AEG-ELECTROLUX DAV75X

[. . . ] Bauelemente . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Onderdelen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Componentes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Componentes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Filtri antigrasso metallici Metal grease filters Filtres graisses mtalliques Metall-Fettfilter Metalen vetfilters Filtro antigrasa metlicos Filtros metlicos antigordura Filtri al carbone attivo Charcoal filters Filtres charbon actif Aktiv-Kohlefilter Aktief koolsfilter Filtro de carbn activo Filtros de carvo activo Illuminazione Lighting Eclairage Beleuchtung Verlichting Iluminacin Iluminao 8 14 20 27 34 41 48 8 14 20 27 34 41 48 8 14 20 27 34 41 48 Pulizia Cleaning Nettoyage Pflege Reiniging Limpieza Limpeza 3 Part 1 - INSTALLATION INSTRUCTIONS 1 - GENERAL INFORMATION This hood is designed for installation over a cooking appliance fitted into a peninsular or island kitchen cabinet. The hood can be fixed to the ceiling or to a wooden buttress (fig. The hood is supplied complete with a substantial ceiling fixing system which is fully adjustable in height to suit most installation requirements. This canopy hood is designed to be used either in the extraction mode (ducted to the outside) or in the recirculation mode (internal recycling). Before commencing the installation, consideration should be given to the difficulties to be found during installation and to the bulky weight of the hood. The installation work must be undertaken by a qualified and competent person in conformity to the rules concerning the evacuation of contaminated air. The manufacturer disclaims all liability for any damage or injury caused as a result of not following the instructions for installation contained in the following text. 2 - COMPONENTS The cooker hood is made up of the following components (fig. 1 canopy item "C", including controls, worktop illumination and fan unit 2. 2 - no. 1 telescopic chimney stack formed by: no. 1 recirculation venting grille item "G" 2. 4 - no. 1 recirculation spigot item "F" 2. 5 - no. 1 reduction flange 150-200 item "R" 3 - SAFETY WARNINGS 3. 1 - The cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric such as a central heating flue or water heating flue. 3. 2 - Ensure that the mains voltage corresponds with the voltage on the rating plate inside the hood. 3. 3 - Connect the cooker hood to the mains via a double pole switch which has 3 mm clearance between the contacts. 10 Part 1 - INSTALLATION INSTRUCTIONS 3. 5 - The hood must be positioned at least 65 cm above a cooking appliance. 3. 6 - Never do flamb cooking under this cooker hood. 3. 7 - Never leave frying pans unattended during use as overheated fats and oils may catch fire. 3. 8 - Before carring out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 3. 9 - If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with other appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 4 - Installation To install the hood proceed by fitting the components in the following order: 4. 1 - Fitting of upper telescopic frame "TS" 4. 2 - Fitting of lower telescopic frame "TI" 4. 3 - Setting the hood for recirculation or evacuation 4. 4 - Connection to the mains supply 4. 5 - Fitting the chimney 4. 6 - Fitting the canopy 4. 7 - Electrical connection of controls and functional test 4. 1 - Fitting of upper telescopic frame "TS" The frame is suitable for fixing to the ceiling as illustrated in (2A) or to a wooden buttress (2B) of adequate thickness and well secured to the ceiling or other carrying structure. Remember that the recycled air can be directed in four different directions: such choice must be made when securing the upper frame (see point "d"). a) Separate the lower frame "TI" (6C) from the upper part "6A" by loosening the four retaining screws "6B" with the socket head screw wrench provided "6D". [. . . ] 2 - Replacement: a) Remove the grease filters "8D" (one at a time) by means of handles "8E", pushing these towards the rear part of the hood and at the same time pulling downwards. b) Remove the two filters "11A" by means of levers "11B". IMPORTANT: The indicated maintenance schedule must be followed to prevent the possibility of fire if the filter is saturated with grease. 3. 3 - Lighting This consists of four 20 W halogen lamps. 12): a) Remove the two screws "12B". [. . . ]