User manual AEG-ELECTROLUX DB413S

[. . . ] Special tools are required to repair a damaged mains cord. To repair this or any other fault please contact your specialist dealer or your local customer service centre. Repairs to electrical appliances may only be carried out by qualified specialists!Repairs carried out by inexperienced persons may cause serious injury to the user. 12 g Technical Data Power consumption: 1600W Mains voltage: 230V Dry Ironing 0 Set the steam selector (Figure 1/F) to position "0" (Figure 4/A). [. . . ] When switched on, the power indicator lamp lights up (Figure 1/J); it goes out when the temperature set has been reached. However, if the temperature selector (Figure 1/N) is turned back, please note that it takes a while for the soleplate to cool down. Only when the power indicator light comes on again has the soleplate reached the cooler temperature. Water Quality You can use tap water up to 3 mmol/I 17° dH water hardness level. Your local Water Authority can advise you on the hardness of the water in your area. If the water from your tap is harder than the above, please use distilled water available from a chemist or a 50:50 mixture of tap water and distilled water. Never use battery water under any circumstances! When using for the first time, please note: 0 Fill the reservoir with water; set the steam selector (Figure 1/F) to position "3" (Figure 4/B). 0 Heat the appliance and place it with the soleplate facing downwards on an iron rest or plate (Figure 5) to allow the water to steam through and activate the steam chamber. 3 You will obtain optimal steaming results and the noise produced by the steaming will be steadier after the water reservoir has been filled and drained three times. 13 g Ironing with Steam To steam iron, set the temperature selector (Figure 1/N) to the required fabric type and wait until the power indicator (Figure 1/J) goes out - only then set the steam selector(Figure 1/F) to position "1" (Figure 4/B), "2" or "3" . You will find which temperature setting (fabric type) matches which steam setting in the ironing table. As soon as the iron is held horizontally steam begins to form. When the iron is set upright again the steam supply stops automatically. Steaming hanging items of clothing 0 Turn the temperature selector (Figure 1/N) to the "max. " position and wait until the power indicator (Figure 1/J) goes out. Set the temperature selector (Figure 1/N) to "max. ". Wait until the power indicator (Figure 1/J) goes out. Place the appliance horizontally on an iron rest or plate (Figure 5). Set the steam selector (Figure 1/F) to position "3" (Figure 4/B) and allow all the mixture to flow through. 0 0 0 0 0 0 0 0 0 15 g What to do, if . . . · no "steam" appears when using on a steam setting?­ In warm, dry air (during the winter), reduced amounts of vapour are normal because it is absorbed by the dry air before condensing. ­ Emptying the filled water reservoir can wash out fluff. Remove the mains cord and tip the filled appliance forwards at an angle (Figure 7) so that the water can run out of the filling aperture. · drops of water are coming out of the steam exit holes?­ Do not set the steam selector to position "1" or higher until the temperature for steam ironing has been reached. If the temperature has been set too low for steam ironing increase the setting. · stains appear on the washing while ironing? [. . . ] · Deposit the plastic bag made of polyethylene (PE) at a PE collection point for recycling. · Padding materials are made of foamed polystyrene (PS). Please inquire with your local authority about your local recycling centre. Customer Service Our products are of the highest quality. Should you nevertheless have questions concerning the use of this appliance, please write to us. [. . . ]