User manual AEG-ELECTROLUX DBS2300

[. . . ] The safety information above all should be followed on the first pages of these operating instructions!Please keep the operating instructions for later reference. Pass them on to any future owner of the appliance. Fittings (figs. 1, 2 and 3) A B C D E F G H J K L M Iron Iron temperature indication lamp Temperature selector Steam jet button Iron rest plate (removable) Hood Rating plate Base Water tank (removable) Power supply cable On/Off switch Signal lamps a Operating indication lamp b Steam generator temperature indication lamp c Exchange descaling cartridge indication lamp N Connecting cable with hose Iron ­ base DBS 200 only: O Spray button P Spray nozzle Q Cable holder Mc AUTO-STOP safety system indication lamp DBS 100: DBS 200: R Steam regulator R Steam regulator with 2 stages with 3 stages medium maxi medium maxi TURBO SHOT 1 Caution! [. . . ] Refer to "Water quality" for choice of water. 1 Never fill the water tank with hot water. Never add alcoholic substances or essences (perfume, eau de Cologne, lavender water, etc. ) to the water. 0 Press the water tank firmly back into its case. 0 Connect the appliance to the power supply. The operating indication lamp lights (fig. 0 Set the temperature selector for steam-ironing between GG and GGG (fig. 8). 13 g 0 Wait until the steam generator temperature indication lamp in the base extinguishes (approx. 0 Press steam jet button until steam emerges (fig. 12) Select the steam volume according to the type and condition of the textiles: very dry or damp textiles, textiles which absorb water to a greater or lesser degree. 2/R) If the steam button is pressed, the iron produces a strong jet of steam for several seconds before the steam emission is normal again. To produce this effect again stop the steam output for a few seconds and the special TURBO SHOT system regulates the maximum steam output without undesired emission of water. 1 3 If there is no more water in the tank, the steam jet button should no longer be operated. 1/B) and extinguishes when the temperature set is reached. If, however, the temperature selector (fig. 1/C) is turned back again at any time, it must be noted that cooling of the sole-plate takes a little time. It has only cooled to a low temperature when the iron temperature indication lamp lights. Indication lamp for exchange of descaling cartridge When the descaling cartridge is used up, the signal lamp flashes indicating exchange of descaling cartridge required (fig. If the descaling cartridge is not changed, the water control system itself interrupts the supply of steam after a time. To obtain steam again the cartridge must be renewed (or if previously operated with mains water, distilled water can be used for a short time). Exchanging the descaling cartridge A new descaling cartridge can be obtained from the customer service or in the specialist trade (E-no. After exchanging the descaling cartridge switch the appliance off and then on again. 15 g Water quality The following may be used: · Mains water · Distilled water · Condensation from laundry drier, which has previously been filtered with a coffee filter. The following must not be used: · Rain water · Defrosting water from refrigerator or similar units · Water supplied from a water softener if this operates with regeneration salts (these are incompatible with the water control system) AUTO-STOP safety system (DBS 200 only) If the iron is securely placed on the rest plate and the steam jet button is not operated for at least 20 minutes, the AUTO-STOP switches off the electrical power supply to the appliance automatically. 2/Mc) and the steam generator temperature indicating lamp (fig. The power supply is connected again after operating the steam jet button. The steam generator temperature indication lamp lights and the AUTO-STOP signal lamp (fig. [. . . ] Mit dieser Garantie haften wir dafür, dass dieses neu hergestellte Gerät im Zeitpunkt der Übergabe vom Händler an den Verbraucher die in unserer Produktbeschreibung für dieses Gerät aufgeführten Eigenschaften aufweist. Ein Mangel liegt nur dann vor, wenn der Wert oder die Gebrauchstauglichkeit dieses Geräts erheblich gemindert ist. Zeigt sich der Mangel nach Ablauf von sechs (6) Monaten ab dem Übergabezeitpunkt, so hat der Verbraucher nachzuweisen, dass das Gerät bereits im Übergabezeitpunkt mangelhaft war. Nicht unter diese Garantie fallen Schäden oder Mängel aus nicht vorschriftsmäßiger Handhabung sowie Nichtbeachtung der Gebrauchsanweisungen. [. . . ]