User manual AEG-ELECTROLUX DD 8696

[. . . ] La distance minimale entre la surface de support des récipients de cuisson et la partie la plus basse de la hotte de cuisine doit être d'au moins 40 cm si la table de cuisson est équipée de foyers électriques. Installation sur les tables de cuisson au gaz de 60 et 70 cm distance minimale de 40 cm installation sur les tables de cuisson au gaz de plus de 70 cm distance minimale de 55 cm Si les instructions d'installation du dispositif de cuisson au gaz spécifient une plus grande distance, il faut en tenir compte. When used as an extractor unit, the hood must be fitted with a hose having preferably the same diameter as the outlet hole. Should there already be a pipe of diameter 125 or 120 mm that ducts to the outside through the walls, it is possible to use the 150/125120 mm reduction flange provided. [. . . ] Every time the cooker hood is used, check whether the L2 LED is lit. L2 LED - carbon filter indicator The LED lights up in orange when the carbon filter needs to be cleaned/replaced; this happens approximately every 160 hours of operation. Every time the cooker hood is used, check whether the L2 LED is lit. Resetting the filter saturation warning After cleaning or replacing the filters, switch on the cooker hood at any suction speed (power), then press and hold the knob for more than 3 seconds, until you hear a beep indicating that the reset procedure has been performed successfully. the L2 LED and the cooker hood both switch off. In some situations (for example, when the L2 LED is indicating that the grease filters and the carbon filter are saturated), the procedure described above must be repeated. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. The front panels should also be washed by hand every 4 weeks using a neutral liquid detergent. To access the grease filter, first remove the front panels which conceal the grease filter. Repeat the operation for all the small panels. Pull the handle downards, then extract the filter. 4 Hand washing Soak grease filters for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). After having re-installed the grease filter, remount the front panels following the instructions for removal in reverse. [. . . ] When calling, please be ready to specify: 1. ) This information is shown on the registration plate inside the unit behind the grease filter. In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local Service Force Centre by telephoning: 08705 929 929 Your call will be automatically routed to the Service Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www. [. . . ]