User manual AEG-ELECTROLUX DD 8891

[. . . ] Sur le côté supérieur près du plafond, insérer deux goujons (11) pour parois (si lon utilise la hotte dans la version filtrante, monter le déflecteur F sur la structure de support au moyen de 2 vis) et fixer la structure de support G au moyen de deux vis (12). The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. [. . . ] depressing the push-button again exits the function. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: DD 8990 only: Set the hood in OFF. press buttons 4 and 5 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will light up, but when the charcoal filter LED C lights up the saturation indicator will be enabled. To disable it: Press buttons 4 and 5 again simultaneously and hold them for 3 seconds, until the charcoal filter LED goes out. LED F will start to flash when it is time to clean the grease filter. Cleaning will be necessary after 40 working hours. Always comply with the maintenance instructions for the grease filter. The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced. This operation is necessary after approximately 160 working hours. After cleaning or replacing the filters, press button 1 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing. Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hoods front panel: A - OFF ON push button Press once or more to obtain the function desired: ON: the hood switches on to the last speed selected. OFF: all the functions are switched off except the illumination. b - Speed selection push button (extraction power). Press this push button once or more to select the most suitable extraction speed (power) (1-2-3). [. . . ] 1 deflector , 1 support bracket , 1 chimney support, 6 wood-screws 5 x 45 mm (for wall mounting) , 6 Dübel Ø 8 mm (for wall mounting) , 1 reduction flange Ø 125-120 mm , 1 allen spanner (for TORX screws). DD 8665-8695-8861-8891-8990: 2+2 metal screws 3, 5 x 9, 5 (to fix the deflector), 2 metal screws 2, 9 x 6, 5 (to fix the chimney) DD 8625-8821: 4 metal screws 2, 9 x 6, 5 (2 to fix the deflector - 2 to fix the upper chimney), 2 metal screws 3 x 9 (to fix the lower chimney). Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. [. . . ]