User manual AEG-ELECTROLUX DD6590-M

[. . . ] It is very important to clean the hood and replace the filter at the recommended intervals. Failure to do so could cause grease deposits to build up, resulting in a fire hazard. The appliance is not intended for use by young children or infirm persons without supervision. Older children must be supervised if using the appliance. [. . . ] This operation should be performed ONLY after having carried out the maintenance of the filters. Display - shows: Suction speed (power) Fat filters saturation: the letter F appears on the display Carbon filter saturation: the letter C appears on the display Note: the letter C appears even if the filter has not been installed (functioning of the hood in the suction version); in any case press key 3 as described above to carry out resetting. timer activated: the letter "t" appears on the display 5. Timer ON/OFF: pressing this key, any suction speed (power) selected will continue to function for 5 minutes, after which the hood will switch off. Press key 5 or 6 to exclude the Timer before end. The hood must always be disconnected from the electricity supply before beginning any maintenance work. The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. removing the metal grease filters · Push it towards the back of the unit and then pull it down and out. Hand washing Soak grease filters for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre. Arrange the carbon filter as a cover to protect the suction motor, fixing it with the two screws supplied. Always specify the hood model code number and serial number when ordering replacement filters. [. . . ] Determine the X and Y dimensions and mark the position of the two holes with a pencil. Then carry out the perforation (2 x Ø 12 mm); insert the two hooks with dowels (3). Remove the fat filter (4), hang the hood up, adjust its horizontal position with the adjustment screws (5). Fix the flue support bracket (7A ­ Suction version) or the deflector (7F ­ Filtering version) with the Ø 8 mm dowels and the Ø 5x45 mm screws at 3-4 mm distance from the ceiling with the hood centred and perfectly horizontal. [. . . ]