User manual AEG-ELECTROLUX DD6690-M

[. . . ] Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied) . Make sure that the outlet of the extension pieces 14. Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a twopole switch having a contact gap of at least 3 mm. Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 1, making sure that they are well seated. Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. lower exhaust Chimney · Slightly widen the two sides of the chimney and hook them between the upper chimney and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. Displays the set speed Displays the set speed Displays the set speed Displays HI The spot flashes Displays the time remaining before the hood turns off (countdown) and the Set speed. The spot at the bottom right flashes Turns the suction motor on and off Decreases the speed of the motor V3 V2 V1 Increases the speed of the motor V1 V2 V3 Starts maximum suction speed. After 5 minutes the speed will return automatically to the one set before. This function can be deactivated by pressing the button again (the decimal point at the centre of the display will flash). Enables automatic delayed shutdown of the appliance (Delay), with a delay that depends on the working speed set. [. . . ] (The colour of the filter surface may change throughout the time but this has no influence to the filter efficiency). When fitting the filters into the hood pay attention that they are mounted in correct position the handle facing outwards. This filter cannot be washed or regenerated. [. . . ]