User manual AEG-ELECTROLUX DD8690-M

[. . . ] · The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. 64 · It is advisable to apply for authorization from the relevant controlling authority when connecting the outlet to an unused chimney flue or combustion gas duct. The air outlet installation must comply with the regulations laid down by the relevant authorities. · When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole. [. . . ] D - Indicates speed 2 (LED) and indication of the active carbon saturation for the filter (flashing indicator). E - Indicates speed 3 F - Indicates Intensive speed (LED). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood revert to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will automaticly be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. H - Light ON/OFF Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. 68 Filter checking device for the detection of grease and active carbon This type of vapour hood is predisposed with a device that signals when the grease or active carbon filter requires cleaning (sold with the active carbon filter by the manufacturer specialized in ventilation equipment). This type of vapour hood is supplied by the manufacturer without the active carbon filter, therefore the saturation signal is disabled. The hood is purchased with active carbon filter included, and the saturation signal is activated as follows: Depress and hold the A and B buttons simultaneously for 3 seconds. Initially only the LED indicator signal for the grease filter C is activated, shortly after the LED indicator for the active carbon filter D will activate, at this point the saturation detection has been enabled. To switch off the saturation detection : depress and hold the A and B buttons for 3 seconds until the LED indicator for the active carbon filter is flashing. Led ­ Indicator for grease filter C The LED indicator for the grease filter will flash when it requires cleaning. Follow the maintenance instructions. Led - indicator for active carbon filter D The LED indicator for the active carbon filter illuminates when the filter requires replacing. 4 a a 71 Warning · Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. · The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb · · · · · Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. 5 72 Cleaning · Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor's protective grid. · Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. · Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. [. . . ] Electrical connection 220-240 V ­ by means of fixed power cable with plug. (Fixed connection of the appliance must only be carried out by an authorised electrician. ) 77 Wall unit mounting - Fig. 6 · Sign the wall with a center line, this will aid mounting procedure (1), position the template so that the mid line printed on the template matches with the center line previously signed, the lower side of the template corresponds to the lower side of the hood once mounted (2). · Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws (3). [. . . ]