User manual AEG-ELECTROLUX DD8694-M

[. . . ] The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please re-fer to the paragraphs on working dimensions and installation). Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. The route of the flue must be as short as possible. [. . . ] Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied) . Connecttheairoutletconnection15 tothehood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. Connect the hood to the mains through a twopole switch having a contact gap of at least 3 mm. 1, making sure that they are well seated. Slightlywidenthetwosidesofthechimneyand hook them between the upper chimney and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. Displays the set speed Displays the set speed Displays the set speed Displays HI The spot flashes Displays the time remaining before the hood turns off (countdown) and the Set speed. The spot at the bottom right flashes Turns the suction motor on and off Decreases the speed of the motor V3 V2 V1 Increases the speed of the motor V1 V2 V3 Starts maximum suction speed. After 5 minutes the speed will return automatically to the one set before. This function can be deactivated by pressing the button again (the decimal point at the centre of the display will flash). Enables automatic delayed shutdown of the appliance (Delay), with a delay that depends on the working speed set. Speed 1 delay 20 minutes Speed 2 delay 15 minutes Speed 3 delay 10 minutes The proposed delay time can be changed by pressing the button successively and selecting one of the options available (5, 10, 15, 20, 25 and 30 minutes). at the end of the time selected the appliance will turn off automatically. [. . . ] Press and hold button E (Delay) for 5 seconds, until confirmation appears on the display: · Fit the new filter and fasten it in its correct position. Put the metal grease filters in their seats. Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood. [. . . ]