User manual AEG-ELECTROLUX DD8695-A

[. . . ] DD 8625 - DD 8665 DD 8695 - DD 8861 DD 8891 - DD 8990 DD 8821 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Safety procedure Self-activation of Automatic (SAFETY) mode: if the sensors reveal an excessive increase in temperature, even if the hood is in Manual mode, the system self selects the Automatic mode and the hood selects the necessary speed. The hood can be turned off by pressing push switch 1. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. 69 Control Panel - DD 8861-8891-8821 Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hoods front panel: ab Fig. Press buttons 4 and 5 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will light up, but when the charcoal filter LED C lights up the saturation indicator will be enabled. To disable it: Press buttons 4 and 5 again simultaneously and hold them for 3 seconds, until the charcoal filter LED goes out. Grease filter LED (F) LED F will start to flash when it is time to clean the grease filter. Cleaning will be necessary after 40 working hours. Always comply with the maintenance instructions for the grease filter. Charcoal filter LED (C) The charcoal filter LED C will start to flash when the charcoal filter needs to be replaced. This operation is necessary after approximately 160 working hours. Resetting the saturation indicator After cleaning or replacing the filters, press button 1 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing. 71 Control Panel - DD 8695-8665-8625 Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hoods front panel: A - OFF ON push button Press once or more to obtain the function desired: ON: the hood switches on to the last speed selected. OFF: all the functions are switched off except the illumination. B - Speed selection push button (extraction power). Press this push button once or more to select the most suitable extraction speed (power) (1-2-3). C - The display shows the extraction power selected, signalling the saturation of the filters (F). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. [. . . ] If you require Customer Service in the Republic of Ireland please contact us at the address below: AEG Electrolux Group (Ire) Ltd Long Mile Road Dublin 12 Republic of Ireland Tel: + 353 (0) 1 4090751 Email: service. eid@electrolux. ie 78 CUSTOMER CARE DEPARTMENT For general enquiries concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www. aeg. co. uk Customer Services Department Major Appliances AEGElectrolux Addington Way Luton Bedfordshire LU4 9QQ 08705 350 350 (*) * calls to this number may be recorded for training purposes. Technical Details Models: DD8625 Dimensions (in cm): Height 82, 3-125, 7 Width 119, 8 Depth 45 Maximum absorbed power (W): 255 Motor (W): 175 Lighting (W): 4x20 Length of the cable (cm): 150 Electrical connection (V): 230 Fuse rating: DD8665/8695 72, 7-108, 7 59, 8/89, 8 45 215 175 2x20 150 220-240 DD8861/8891 72-114 59, 8/89, 8 45 215 175 2x20 150 220-240 DD8990 72-114 89, 8 45 215 175 2x20 150 220-240 DD8821 79-123 119, 8 45 255 175 4x20 150 220-240 Mounting accessories included 1 deflector , 1 support bracket , 1 chimney support, 6 wood-screws 5 x 45 mm (for wall mounting) , 6 Dübel Ø 8 mm (for wall mounting) , 1 reduction flange Ø 125-120 mm , 1 allen spanner (for TORX screws). DD 8665-8695-8861-8891-8990: 2+2 metal screws 3, 5 x 9, 5 (to fix the deflector), 2 metal screws 2, 9 x 6, 5 (to fix the chimney) DD 8625-8821: 4 metal screws 2, 9 x 6, 5 (2 to fix the deflector - 2 to fix the upper chimney), 2 metal screws 3 x 9 (to fix the lower chimney). 79 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. [. . . ]