User manual AEG-ELECTROLUX DD8794M/S

[. . . ] in this case the hood will be slightly noisier. Attention: The hose is not supplied and must be purchased separately. The distance between the cookware support surface on top of the cooking appliance and the lowest part of the cooker hood must be at least 30 cm for electric cookers or, where a gas hob is fitted, if the cooker hood is the 60 cm size (DD 8765 model): installation above a 60 cm gas hob - minimum distance 30 cm installation above a 70 cm gas hob - minimum distance 45 cm installation above gas hobs larger than 70 cm is not possible if the cooker hood is the 90 cm size (DD 8794-8795 -HD 8795 model): installation above a 60 cm or 70 cm gas hob - minimum distance 30 cm installation above gas hobs larger than 70 cm - minimum distance 45 cm If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. [. . . ] Fixed red light: Cooker hood operating at power level 3 (maximum). Flashing red light: Cooker hood operating at an intensive power level (for a duration of 5 minutes, after which the appliance automatically selects power level 3). The cooker hood is fitted with a device which indicates when the filter must be cleaned or replaced. Usually the device, which signals when the carbon filter needs maintenance work, is deactivated. The L2 LED begins to flash in green and after approximately 2 seconds the L2 LED will also begin to flash in orange, to indicate that the device, which indicates when it is necessary to perform carbon filter maintenance, has been activated. The LED lights up in green when the grease filter needs to be cleaned; this happens approximately every 40 hours of operation. Every time the cooker hood is used, check whether the L2 LED is lit. The LED lights up in orange when the carbon filter needs to be cleaned/ replaced; this happens approximately every 160 hours of operation. Every time the cooker hood is used, check whether the L2 LED is lit. After cleaning or replacing the filters, switch on the cooker hood at any suction speed (power), then press and hold the knob for more than 3 seconds, until you hear a beep indicating that the reset procedure has been performed successfully. the L2 LED and the cooker hood both switch off. To do this you will need an original charcoal filter (available from your local Service Force Centre). Cleaning/replacing the charcoal filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. With normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, on avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the filter, the filter should be dried in an oven for 10 minutes with a maximum temperature of 100ºC. After approximately three years of use, the charcoal filter should be replaced with a new, as the odour reduction capacity will be reduced. Fitting Fit the charcoal filter on the rear side of the grease filter, fix it with two metal wires. The metal wires charcoal filter are included in the carbon filter packing and not on the metal wires hood · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. [. . . ] If the light does not come on, make sure the bulb has been inserted Fig. 9 correctly before contacting your local Service Force Centre. You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. for service in Australia call 1300 650 020. [. . . ]