User manual AEG-ELECTROLUX DD8795-M-A

[. . . ] DD 8795 User manual Cooker Hood Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 1 Recirculation Version · The air is filtered through charcoal filters and returned to the kitchen. · You will need original charcoal filters for the recirculation function. (Available from your local Service Centre). · Fix the deflector using 2 screws Ø 3. 5x9. 5 mm. 2 6 Control Panel · Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. · Cooker hood operation can also be controlled using the remote control (the remote control is an L2 accessory and may be ordered separately). L1 The control panel consists of a knob and 2 LEDs; it is located at the bottom right-hand side of the cooker hood. Fig. 3 · To switch the lights on and off: Press and release the knob to switch the lights on; press and release it again to switch them off. Note: in some models it is possible to select one of 2 different lighting intensity levels. · To select an available suction speed (power) level: Turn the knob in a clockwise direction to increase the suction speed (power); turn it in an anticlockwise direction to decrease the power until the hob is switched off. The cooker hood is fitted with an LED (L1) which indicates the suction speed (power) selected by displaying different colours: · Light off: Suction motor switched off. · Fixed green light: Cooker hood operating at power level 1 (minimum). · Fixed orange light: Cooker hood operating at power level 2 (medium). · Fixed red light: Cooker hood operating at power level 3 (maximum). · Flashing red light: Cooker hood operating at an intensive power level (for a duration of 5 minutes, after which the appliance automatically selects power level 3). 7 Filter checking device The cooker hood is fitted with a device which indicates when the filter must be cleaned or replaced. Usually the device, which signals when the carbon filter needs maintenance work, is deactivated. To activate it, proceed as follows: Switch off the cooker hood. Press and hold the knob for approximately 5 seconds. The L2 LED begins to flash in green and after approximately 2 seconds the L2 LED will also begin to flash in orange, to indicate that the device, which indicates when it is necessary to perform carbon filter maintenance, has been activated. L2 LED - grease filter indicator The LED lights up in green when the grease filter needs to be cleaned; this happens approximately every 40 hours of operation. Every time the cooker hood is used, check whether the L2 LED is lit. L2 LED - carbon filter indicator The LED lights up in orange when the carbon filter needs to be cleaned/replaced; this happens approximately every 160 hours of operation. [. . . ] Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. 13 Technical Specifications Dimensions (in cm): Height Width Depth Maximum absorbed power (W): Motor (W): Lighting (W): Length of the cable (cm): Electrical connection (V): 80 89, 8 33, 5 235 175 3x20 150 230 Mounting accessories included 1 allen spanner (for TORX screws). 1 support bracket 1 deflector 2 Screw caps 1 Rubber strip (cut in 3 equal parts) 1 template 2 spacers 4 wood-screws 5 x 45 mm 4 wall plugs Ø 8 mm 2 metal screws 3, 5 x 32 2 metal screws 3, 5 x 9, 5 2 metal screws 5 x 18 2 flanges Ø 150 mm 2 Stainless Steel side panels Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. [. . . ]