User manual AEG-ELECTROLUX DD8890-A

[. . . ] DD 8890 - DD 8820 HD 8890 - HD 8820 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Optionally, the position of the chimney elements can be changed. When using the hood in the filter version the chimney must be fixed at the top, with the air outlet grill at the side. 56 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the units front panel. 2 1 2 3 4 5 6 1 - Mains switch, ON/OFF Press for less than 1 1/2 seconds and the cooker hood goes into the "stand by" position (point "b" is illuminated). Press for more than 1 1/2 seconds and the cooker hood turns off, ALL the controls (except the light push button) are disabled (the display is off). Press again for more than 1 1/2 seconds to reset the cooker hood to "stand by". 2 - Light ON/OFF 3 - Display 4 - Start and choice of motor speed 1-2-3-1-2. . . . . . . . . The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood will revert to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will automatically turn off after 5 minutes. To interrupt the Intensive speed, press button 1 or 5. The letter P appears on the display and the remaining time (the point a is flashing), if interrupted an acoustic signal is heard. 6 - Self-Timer: times all the speed levels (the point b is flashing), and then the cooker hood switches off: The self-timer is set as follows: 1st speed level 20 minutes 2nd speed level 15 minutes 3rd speed level 10 minutes The display shows the remaining operation time, at the end of the time an acoustic signal is heard. Depressing the push-button again exits the function. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating correctly. 57 Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Press buttons 4 and 5 simultaneously and hold them for 3 seconds. At first only the grease filter LED F will illuminate, but when the charcoal filter LED C illuminates the saturation indicator will be enabled. To disable it: Press buttons 4 and 5 again simultaneously and hold them for 3 seconds, until the charcoal filter LED C goes out. Grease filter LED (F) LED F will start to flash when it is time to clean the grease filter. [. . . ] 63 Special accessories Charcoal filter TYPE 20 Technical Specifications Model DD 8890 HD 8890 DD 8820 HD 8820 Dimensions - extractor version (in cm): Height 68, 5-113, 4 Width 89, 8 Depth 46 Dimensions - filter version (in cm): Height 77, 2-123 Width 89, 8 Depth 46 Maximum absorbed power: 215 W Motor absorption: 1 x 175 W Lighting: 2 x 20 W Lengthof the cable: 150 cm Electrical connection: 220 - 240 V 68, 5-113, 4 119, 8 46 77, 2-123 119, 8 46 255 W 1 x 175 W 4 x 20 W 150 cm 220 - 240 V Mounting accessories included 1 chimney support 1 reduction flange Ø 125-120 mm 1 deflector 1 allen spanner (for TORX screws) 1 support bracket 6 wood-screws 5 x 45 mm (for wall mounting) 6 wall plugs Ø 8 mm (for wall mounting) 2 metal screws 2, 9 x 6, 5 (for chimney flue mounting) DD 8890 - HD 8890 only 4 metal screws 3, 5 x 9, 5 (to affix the deflector to the support) DD 8820 - HD 8820 only 4 metal screws 2, 9 x 6, 5 (2 for chimney flue mounting + to affix the deflector to the support) 64 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. [. . . ]